OM-1076-001.pdf - 第137页
0206-001 2-106 Tg0502-PM-CL
3. Max. and Min. Sizes by View Range
The maximum and Minimum sizes by view range are shown in the
following table.
Minimum Size by View Range
Component Shapes Item Small View Large View
Leadless Cyindrical Minimum Mold Size (mm) Long Side 1.0
×
Short Long Side 2.0
×
Short
Component
Side 0.5 Side 1.2
Square Minimum Mold Size (mm) Long Side 1.0
×
Short Long Side 2.0
×
Short
Side 0.5 Side 1.2
Deform Minimum Mold Size (mm) Long Side 1.0
×
Short Long Side 2.0
×
Short
(Simple) Side 0.5 Side 1.2
Deform Minimum Linear Edge Width
1.60 3.00
(Complex)
(mm)
Leaded IC Minimum Lead Width (mm) 0.10 0.18
Component
Minimum Lead Length (mm) 0.17 0.30
Minimum Lead Pitch (mm) 0.20 0.40
Connector Minimum Lead Width (mm) 0.10 0.18
Minimum Lead Length (mm) 0.17 0.30
Minimum Lead Pitch (mm) 0.20 0.40
Other Minimum Lead Width (mm) 0.17 0.30
Minimum Lead Length (mm) 0.17 0.30
Minimum Lead Pitch (mm) 0.20 0.40
Area Array BGA/CSP Minimum Ball Diameter (mm) 0.20 0.40
Minimum Ball Pitch (mm) 0.30 0.55
(a) For small view range, the maximum component size obtained is based
on the outline size, pick-up position correction, and component sup-
plying direction. For large view range (back lighting), it is based on the
range necessary for the recognition and pick-up position correction.
For large view range (front lighting), it is based on the range neces-
sary for the recognition and component supplying direction.
(b) The component shapes applicable for dividing view are deform (com-
plex), IC, connector and BGA/CSP.
(c) For components with outside dimensions of 10
×
10 mm or less, the
maximum component thickness is 6.5 mm.
Maximum Size by View Range
Item Small View Large View
Max. Component Size for Total View (mm) Front Ltg 24
×
18 46
×
34
Note (a) Back Ltg 18
×
18 18
×
18
Max. Component Size for Divided View (mm) Front Ltg 55
×
55
(or 100
×
26)
Note (b) Back Ltg
Max. Component Thickness (mm) 5 Note (c) 20
0206-001 2-105 Tg0502-PM-CL
3. Max. and Min. Sizes by View Range
Table B24
Table B23
0206-001 2-106 Tg0502-PM-CL
Section 3
Naming Standards of Component Library
0107-001 3-A Tg0502-PM-CL
This section describes how to understand component IDs
based on the naming standards of the component library.