YSP10_Mainte_E.pdf - 第116页
Appe ndix Contents 1. S pecification A- 1 1. 1 Air r egulat or unit A-1 1. 1.1 Supply air pres sure A-1 1.2 Po wer connection t erminals A-2 1.3 Connect ion betw een machines A-3 1. 3.1 PREVIOUS INTERF ACE connect or A-4…
2. Lubrication points
5-12
Chapter 5 Lubrication points and schedule
2.5.2 Suction unit
Lubrication section
Lubrication
points
Interval Procedure Nozzle type, and other
Blower hose guide 1
At
replacement
Manual lubrication
Lubricate when the
hose is replaced.
Suction blower unit
Blower hose guide
Blower hose guide
Grease gun
Manual lubrication
53511-KMJ-00
Appendix
Contents
1. Specification A-1
1.1 Air regulator unit A-1
1.1.1 Supply air pressure A-1
1.2 Power connection terminals A-2
1.3 Connection between machines A-3
1.3.1 PREVIOUS INTERFACE connector A-4
1.3.2 NEXT INTERFACE connector A-5
1.4 Adapted mask A-6
1.4.1 The mask flame size and the mask standard position A-6
1.5 Inverter A-7
2. Periodic inspection check sheet A-9
3. User support A-12
3.1 YAMAHA Service website A-12
4. YSP10 Maintenance parts A-13
1.Specication
A-1
Appendix
1. Specification
1.1 Air regulator unit
1.1.1 Supply air pressure
The air regulator unit, which adjusts the air pressure to supply air to the air-driven unit of this machine, is
installed inside the lower panel of the machine front side. Adjust the air pressure to the appropriate value
shown below.
c
CAUTION
Before using the air regulator, make sure that the source air pressure is at least an appropriate value (0.45MPa or higher).
Air regulator unit and air connector
Upper left part of the machine front side Lower left part of the machine front side
Air pressure supply
regulator
Air pressure supply/
shutoff switch
Source air connector
Air filter
Mist filter
Digital pressure gauge
for cleaner
Digital pressure gauge
to check the set pressure
53A01-KMJ-00
►
Digital pressure gauge
Appears set air pressure. Adjust the pressure in between the following values by pressure regulator.
Set air pressure: 0.40MPa to 0.41MPa
►
Digital pressure gauge for cleaner vacuum
Appears air pressure (negative) of cleaner.
►
Source air pressure regulator
Adjusts the source air pressure to an appropriate pressure (0.45MPa or higher). Turn the knob to adjust
the set air pressure to 0.40MPa.
►
Air pressure supply/shutoff switch
Turn this switch to the right to cut off the air supply to the machine and exhaust any remaining air in the
air hose.
►
Source air connector
Connect the air hose with an inner diameter of at least 8mm having a 30SH socket (Nitto Koki, or
equivalent) to this connector and supply compressed air to the machine. Use dry, clean air passed
through an air dryer and air filter.