00196478-08_MM_SX12DX12_en - 第71页
Major Maintenance 5.6.4 Final Work Maintenance Tasks for the Conveyor Maintenance Manual SIPLACE SX1/SX2/DX1/DX2 71 5.6.4 5 . 6 . 4 F in a l W o r k Final Wor k ► Restore the original conveyor configuration .
Major Maintenance
Maintenance Tasks for the Conveyor 5.6.3 Performing Maintenance Tasks
70 Maintenance Manual SIPLACE SX1/SX2/DX1/DX2
Cleaning the Clamping Surfaces on the Basic Carrier (Dual Conveyor Only)
SXDX12 V1 Cleaning the Clamping Surfaces on the Basic Carrier (Dual Conveyor Only)
Preserving the Conveyor - Moving the Sides and Repeating Steps
Moving the Sides and Repeating Steps
► Now move all conveyor sides to the other side of the conveyor. Use the station software to set the
dual conveyor to single conveyor mode (left).
► Now perform the above mentioned cleaning and preserving steps to the other side of the conveyor.
See also
1.2 Preparatory Work... [ ➙ 12]
NOTICE
Width Adjustment
The clamping surfaces in the vicinity of the width adjustment may be difficult to access.
► In this case, move the width adjustment by carefully pulling on its belt, so that you can ac-
cess these areas and clean them.
CAUTION
Make sure that you do not get any oil on the clamping surfaces of the conveyor sides.
If you get oil on the clamping surfaces, their clamping force could be impaired.
► Clean this area thoroughly before you move the conveyor sides, to gain access to any areas
which have not been cleaned.
Overview of the clamping surfaces in the conveyor
NOTICE!
The clamping surfaces/clamping unit do not need to be
cleaned in single conveyors.
► Use a lint-free cloth and ethanol to remove the dirt
and any excess oil on the side clamping surfaces.
► Repeat the procedure for all clamping surfaces in the
conveyor.
Major Maintenance
5.6.4 Final Work Maintenance Tasks for the Conveyor
Maintenance Manual SIPLACE SX1/SX2/DX1/DX2 71
5.6.4
5.6.4 Final Work
Final Work
► Restore the original conveyor configuration.
Major Maintenance
Maintenance Tasks Nozzle Magazines 5.7.1 Tools, Consumables, Spare and Wear Parts
72 Maintenance Manual SIPLACE SX1/SX2/DX1/DX2
5.7
5.7 Maintenance Tasks Nozzle Magazines
Maintenance Tasks Nozzle Magazines
5.7.1
5.7.1 Tools, Consumables, Spare and Wear Parts
Tools, Consumables, Spare and Wear Parts
▪ SIPLACE cleaning tissue [00315253-xx]
5.7.2
5.7.2 Performing Maintenance Tasks
Performing Maintenance Tasks
5.7.2.1
5.7.2.1 Cleaning the Twin Nozzle Magazines
Cleaning the Twin Nozzle Magazines
► Insert the nozzles into the nozzle garages.
► Remove the nozzles from the nozzle garages.
► Clean the nozzles with a SIPLACE cleaning tissue.
CAUTION!
Pay particular attention on the spring retainer.