NR_Mechanischer_Stopper - 第150页

Assembly Instructions PCB Stopper Sin gle Conveyor SIPLACE S-27HM / HS-60 / D4 / D3 / HF- / X-Series Edition 06/2007 150 O Unscrew the cover of the lif ting table bo ard (see the following figure). O Det ach the control …

100%1 / 238
Assembly Instructions PCB Stopper Single Conveyor SIPLACE S-27HM / HS-60 / D4 / D3 / HF- / X-Series
Edition 06/2007
149
13.2 Installation at placement area 2
13.2.1 Install distance pieces and holders
O Only if fixed conveyor side on the left:
Remove the holder for the machine zero point (2 screws).
Note the current position of the holder. This is pinned and can be installed in two different ways.
The holder must be reinstalled later in the same position. So if necessary mark the position
with a pen.
Fig. 124
13
13
13
2 screws
Holder for machine zero point
Assembly Instructions PCB Stopper Single Conveyor SIPLACE S-27HM / HS-60 / D4 / D3 / HF- / X-Series
Edition 06/2007
150
O Unscrew the cover of the lifting table board (see the following figure).
O Detach the control cable with the connector designation X6 on the lifting table board.
Fig. 125
O Detach the cable clamp and the cable tie and pull the pneumatic hose off the lifting table mech-
anism from both sides.
13
13
13
13
Be careful not to damage hoses or cables! 13
Fig. 126
Control cable
Cover of
lifting table
board
Detach cable clamp Detach cable tie
Remove hose
Assembly Instructions PCB Stopper Single Conveyor SIPLACE S-27HM / HS-60 / D4 / D3 / HF- / X-Series
Edition 06/2007
151
O Unscrew the fastening screws of the lifting table marked in Fig. 127 (M8 x 120 mm (blue) / M6
x 80 mm (green)) and lift the lifting table carefully out of the conveyor.
13
Fig. 127 Fastening screws of lifting table
On a single conveyor the lifting table can be lifted out between the conveyor sides. 13
On a dual conveyor the lifting table must be lifted out toward location 2 in the case of left conveyor
and toward location 3 in the case of right conveyor. 13
13
Caution: The lifting table is very heavy (approx. 12 kg). 13
Be careful not to damage the lifting table or the underside of the conveyor! 13
13