NR_Mechanischer_Stopper - 第154页

Assembly Instructions PCB Stopper Sin gle Conveyor SIPLACE S-27HM / HS-60 / D4 / D3 / HF- / X-Series Edition 06/2007 154 O Clean the conveyor tub in the area of the conveyor width adjustment with a lint-free cl oth moist…

100%1 / 238
Assembly Instructions PCB Stopper Single Conveyor SIPLACE S-27HM / HS-60 / D4 / D3 / HF- / X-Series
Edition 06/2007
153
O Install the holders for the guide rail ([03036928-xx] and [03032179-xx]), (narrow holders for
PA1, wide ones for PA2), with one cylinder head bolt (each) with hexagon socket head
M4 x 16-DIN 912 on the lifting table PA2. The holders are installed so that they are flush at the
top with the lateral frames of the lifting table.To prevent the holder from twisting, the lateral
shoulder of the holder must lie against the outside of the frames.
Fig. 129 Guide rail holders
Fig. 130
Guide rail holders at left and right
Guide rail holders
Assembly Instructions PCB Stopper Single Conveyor SIPLACE S-27HM / HS-60 / D4 / D3 / HF- / X-Series
Edition 06/2007
154
O Clean the conveyor tub in the area of the conveyor width adjustment with a lint-free cloth moist-
ened with ethyl alcohol.
The tub should be free of grease as the trailing cables are to be fastened here with double-
sided adhesive tape.
13
13
When you place the lifting table back in the conveyor, be careful not to damage either the con-
veyor, the lifting table (forked light barrier) or cables/hoses. 13
13
O Insert the lifting table. Place it on the distance pieces.
O Remove 3 to 4 segments of the cable duct in the area of the lifting table's forked light barriers.
O Detach the cable clamp for the control cable of the lifting table.
Remove 3 to 4
segments for the forked
light barriers.
Assembly Instructions PCB Stopper Single Conveyor SIPLACE S-27HM / HS-60 / D4 / D3 / HF- / X-Series
Edition 06/2007
155
O Screw the lifting table onto the distance pieces, as shown in the graphic, with six (for dual con-
veyor) or four (for single conveyor) M8 x 70 mm screws (see figure, blue) and two M6 x 80 mm
screws (green).
Fig. 131 Fastening screws of lifting table