NR_Mechanischer_Stopper - 第189页
Assembly Instructions PCB Stopper Single Conveyor SIPLACE S-27HM / HS-60 / D4 / D 3 / HF- / X-Series Edition 06/2007 189 O In conveyor tr ack 2 there is a shaft above the cover of the conv eyor conversion board . Loosen …
Assembly Instructions PCB Stopper Single Conveyor SIPLACE S-27HM / HS-60 / D4 / D3 / HF- / X-Series
Edition 06/2007
188
14.2.2 Removing the conversion board cover
O Unscrew the motor above the conversion board in conveyor track 2 (3 hexagon screws) and
lay it to the side so that it doesn't get in the way when you are removing the conversion board
cover.
Caution: The three screws are of different lengths. Note the positions of the screws for when you
reinstall the motor later.
Fig. 165 Motor above the conversion board in conveyor track 2
Conversion
board cover
Motor
Assembly Instructions PCB Stopper Single Conveyor SIPLACE S-27HM / HS-60 / D4 / D3 / HF- / X-Series
Edition 06/2007
189
O In conveyor track 2 there is a shaft above the cover of the conveyor conversion board. Loosen
the shaft fixations on the outside of the lifting table and push the shaft into conveyor track 1.
Fig. 166 Shaft fixation
O Remove the cover of the conveyor conversion board.
14
O Remove the covers of the two cable ducts in conveyor track 1.
Fig. 167 Cable ducts (conveyor track 1)
Covers of cable
ducts
Assembly Instructions PCB Stopper Single Conveyor SIPLACE S-27HM / HS-60 / D4 / D3 / HF- / X-Series
Edition 06/2007
190
14.2.3 Cable and hose laying
O Lay the bundled cables and hoses, starting with the trailing cable, under the belt for the width
adjustment. Using self-adhessive cable clamps, secure the cables parallel to the cables al-
ready running there, so that they don't touch the belt.
Route the cables back out from under the belt of the width adjustment at the height of the cable
ducts.
Fig. 168 Cable laying
O Place the pneumatic valves next to the conversion board in conveyor track 2. Shorten the
hoses to a reasonable length.
Fig. 169 Pneumatic valves
Cable laying (from right to left)