192277 - Micron Technical Reference Volume 1.pdf - 第78页

COVERS PRINTER COVERS 3.36 Technical Reference Manual Chapter Issue 11, Jan 17 5. Repeat Steps 3 to 4 for the other MMI Arm panel, if required. Full removal of panel requires initial removal of the MMI Arm. Lower Side Pa…

View on Rear of Switch

Switch Release Tool

Switch Body

Contact Assembly

COVERS

PRINTER COVERS

3.36 Technical Reference Manual Chapter Issue 11, Jan 17

5. Repeat Steps 3 to 4 for the other MMI Arm panel, if required. Full removal

of panel requires initial removal of the MMI Arm.

Lower Side Panels To remove the lower side panels, carry out the following:

1. Remove the corresponding safety cover (as detailed previously).

2. Open the front printhead cover.

3. Remove the front lower corner panels (as detailed previously).

4. Remove the front upper corner panels (as detailed previously).

5. Remove the rear corner panels (as detailed previously).

6. Remove the MMI Arm Panels (as detailed previously).

7. Using an 4mm Allen key, undo the two captive screws.

8. Tilt the top of the panel away from the printer and lift the panel clear, taking

care not to damage the earth cable.

Front Right Quarter View

Captive Screws

Front Right Quarter View

Captive Screws

COVERS

PRINTER COVERS

Chapter Issue 11, Jan 17 Technical Reference Manual 3.37

9. Repeat Steps 1 and 6 to 8 for the other lower side panel, if required.

Upper Side Panels To remove the upper side panels, carry out the following:

1. Remove and disconnect the beacon.

2. Remove the corresponding safety cover (as detailed previously).

3. Open the front printhead cover.

4. Remove the upper front corner panel (as detailed previously).

5. Remove the lower front corner panel (as detailed previously).

6. Remove the MMI panel (as detailed previously).

7. Remove the corresponding rear corner panel (as detailed previously).

8. Remove the corresponding front corner panel (as detailed previously).

9. Using an 4mm Allen key, undo the four captive screws.

10. Lift the panel away from the printer, taking care not to damage the earth

cable.

11. Repeat Steps 1 and 6 to 9 for the other upper side panel, if required.

Front Right Quarter View

Captive Screws

(in 4 positions)