SiplaceX4_en - 第458页
1 - 26 S tudent Guide SIPLACE X 9 Component handling Edition 09/2005 26 9.3.12 Settings and function in the Main Menu X- Förderer Fig. 9.3 - 12 Control panel for X-feeder Description of the buttons X-feeder 9 1. "Fo…
1 - 25
Student Guide SIPLACE X
Edition 09/2005 9 Component handling
25
9.3.11 X- Feeder operator panel
Fig. 9.3 - 11 X- Feeder operator panel
1. Operator panel X- Feeder 2. LCD- Display (In the basic view shows
the display the track number and the
step)
3. Button "Forward" 4. Button "Backward"
5. Button "FOIL" 6. Button "SET"
7. Status LED:
– green ---> ready, and the feeder is
used in the current set up
– orange ---> Warning
– red ---> Error
– Display Off ---> Feeder isn‘t use in the
current set up
1 - 26
Student Guide SIPLACE X
9 Component handling Edition 09/2005
26
9.3.12 Settings and function in the Main Menu X- Förderer
Fig. 9.3 - 12 Control panel for X-feeder
Description of the buttons X-feeder 9
1. "Forwards" button:
Press briefly to move the tape by the set cycle step.
Press for longer to move the tape forwards. Make sure the cover foil is not clamped in.
2. "Backwards" button:
Press briefly and the tape is move backwards by the set cycle step.
Press for longer to move the tape backwards. (Only perform these functions when the cover
foil is not clamped in)
3. "Foil" button:
Press to start the drive motor for cover foil. This runs until the foil has been stretched tight and
the motor toggle switch turns off or until the timer has counted 30 seconds.
4. "SET" button:
Briefly press you switch to the next menu in the main menu
Press for longer to request component verification.
Please Note:
If you defined the correct Pitch in Siplace Pro the Software send the corret value to the 8mm X-
Feeder automatically.
Transportdirection
Cycle step
Display showing track on location
1
2
3
4
