00194086-01 - 第111页
User Manual SIPLAC E CS 5 Tasks on the machine Software Vers ion SR.408.xx 03/2006 U S Edition 5.3 Carrying out a walk-through inspe ction 111 5.3.4 Inserting sep arating pl ates in the component trolley tape cont ainer …
5 Tasks on the machine User Manual SIPLACE CS
5.3 Carrying out a walk-through inspection Software Version SR.408.xx03/2006 US Edition
110
5.3.2 Splicing the tape in good time
PLEASE NOTE: 5
Splice the tapes early enough so that the feeders do not become empty. Otherwise you will expe-
rience prolonged down times.
However, do not splice the tapes too early because if you wind the end of the old tape onto the
new reel after splicing, the reel holding the new tape may become overfilled and the tape will slip
off the reel and become tangled up. This will again result in pick-up errors and prolonged down
times.
5.3.3 Checking the PCB supports
Æ
Check the position of the magnetic PCB supports on the lifting table:
– Make sure that the PCB supports do not collide with components on the underside of the
PCBs.
– In addition, make sure that the PCB supports do not collide with the PCB conveyor pan-
els.
User Manual SIPLACE CS 5 Tasks on the machine
Software Version SR.408.xx 03/2006 US Edition 5.3 Carrying out a walk-through inspection
111
5.3.4 Inserting separating plates in the component trolley tape container
Æ Insert the separating plates as shown in Fig. 5.3 - 2 and remember that the smallest division of
the tape container is a 2x division. This will help avoid placement errors.
Æ Check that the separating plates engage in the same positions on both guide rails. Otherwise
the separating plate will be offset or bent.
5
Fig. 5.3 - 2 Inserting separating plates in the component trolley tape container
(1) Guide rail for the separating plates
(2) Tape container
(3) Waste tape container
(4) Supporting rod for the separating plates
(5) Separating plate
5 Tasks on the machine User Manual SIPLACE CS
5.3 Carrying out a walk-through inspection Software Version SR.408.xx03/2006 US Edition
112
5.3.5 Using spindles for large tape reels
Æ Insert spindles into the separating plates when using large tape reels.
PLEASE NOTE 5
We recommend that you use spindles if the tape reel diameter exceeds 15" (381 mm)". This will
ensure that the feeder modules operate reliably.
Fig. 5.3 - 3 Inserting spindles for large reels
(1) Component trolley
(2) Position of the spindles
(3) Separating plate
(4) Spindle (enlarged)