00194086-01 - 第144页

6 Component handling User Manual SIPLACE C S 6.3 Component trolley Software Version SR. 408.xx03/2006 US Edition 144 6.3 Com ponent tro lley 6.3.1 St ructure The com ponent tro lley co nsists essen tiall y of a chassi s,…

100%1 / 160
User Manual SIPLACE CS 6 Component handling
Software Version SR.408.xx 03/2006 US Edition 6.2 Technical data for the S feeder modules
143
6.2.11.2 Technical data
Item no. 00117010-xx 6
Assigned locations 3 6
Component size Max. 36 x 36 mm²
depending on the placement head type 6
Possible coating thicknesses 25, 35, 45, 55, 65, 75 µm 6
Time required to change the coating thickness Less than 1 min. 6
Gap height tolerance ± 5 mm 6
Plate rotating speed Programmable from 0 - 10 sec.
in 0.1 sec. increments 6
Component dip time Programmable from 0 - 2 sec.
in 0.1 sec. increments 6
Flux Highly viscous flux, conductive adhesive 6
6 Component handling User Manual SIPLACE CS
6.3 Component trolley Software Version SR.408.xx03/2006 US Edition
144
6.3 Component trolley
6.3.1 Structure
The component trolley consists essentially of a chassis, a component feeder table on which the
feeder is mounted, a communication unit, a tape container and a waste container. Docking the
component trolley in or out is described in Section 5.8
, page 120 onwards.
Fig. 6.3 - 1 Component trolley
(1) Component trolley
(2) Communication unit
(3) Control button for raising the component feeder table
(4) Component feeder table
(5) Handle for locking and lowering the component feeder table
(6) Tape container
(7) Waste tape container
NOTE ON OPERATIONAL SAFETY
All component trolleys must be docked on the machine in order to operate it. If they are not, the
machine stays in EMERGENCY STOP status. The placement process is interrupted.
User Manual SIPLACE CS 6 Component handling
Software Version SR.408.xx 03/2006 US Edition 6.3 Component trolley
145
6.3.2 Tape container
Reels up to 19" (483 mm) in diameter may be used. Insert them into the separating plates as
shown in Fig. 5.3 - 2
.
PLEASE NOTE 6
We recommend that you use spindles if the tape reel diameter exceeds 15" (381 mm). This will
ensure that the feeder modules operate reliably. 6
6
Fig. 6.3 - 2 Component trolley with tape container
(1) Component trolley
(2) Spindles
(3) Separating plate
(4) Tape container
6.3.3 Compressed air supply for bulk case feeder modules
Bulk case feeder modules require compressed air in order to work. A compressed air supply for
bulk case feeder modules is therefore available as an option.