00197454-01_AI_Portal_40mm_TwinVHF_SX12_de_en - 第120页

assembly Final Wo rk 3.7.3 Checking the Gantry Coding 120 Reconfiguration Kit Twin VHF with Gantry Reconfiguration Ki t T w i n V H F m i t P o r - 3.7.3 3 . 7 . 3 C h e c k in g t h e G a n t r y C o d in g Checking the…

assembly

3.7.1 Empty Tape Duct Intermediate Plate Final Work

Reconfiguration Kit Twin VHF with Gantry Reconfiguration Kit Twin VHF mit Portal 119

3.7

3.7 Final Work

Final Work

3.7.1

3.7.1 Empty Tape Duct Intermediate Plate

Empty Tape Duct Intermediate Plate

If tapes with high components are processed, you will need to remove the empty tape duct intermediate

plate when upgrading a gantry with TwinHead or CPP head and stationary camera.

If you are only using component with tapes up to 12 mm, keep the intermediate plate in the empty tape

duct.

3.7.2

3.7.2 Stowing the Gantry Carrier and the Prepared Case

Stowing the Gantry Carrier and the Prepared Case

Stowing the gantry carrier in the transportation crate

► Use the gantry lift to move the gantry carrier into the transportation crate.

► Fix the gantry carrier into place in the transportation crate, with the 4 fastening screws.

► Release the gantry carrier from the gantry lift and move the gantry lift to one side.

► Place the foam cover for the placement head in the transportation crate.

► Close the front and top cover on the transportation crate.

Placing assembly parts in the "Prepared" case

1. Inlet slot for empty tapes

2. Outlet slot for the empty tapes above the pneumatic

tape cutter

3. Dividing plate for tapes < 12 mm (can be removed for

tapes > 12 mm)

You have removed the following parts which you will

need to dismantle the gantry later on. Keep these parts in

the "Prepared" case.

▪ The long end position buffer

▪ A green lever as transportation lock for the gantry

▪ Two transportation locks for the placement head

▪ Black plastic foil for trailing cable

▪ Trailing cable holder with knurled head screw

assembly

Final Work 3.7.3 Checking the Gantry Coding

120 Reconfiguration Kit Twin VHF with Gantry Reconfiguration Kit Twin VHF mit Por

3.7.3

3.7.3 Checking the Gantry Coding

Checking the Gantry Coding

► Check the DIP switch (1) for the gantry coding of the

locations on the head interface.

Switch Designation Gantry 1 Gantry 2

1 DC/DC OFF OFF

2FANOFFOFF

3P1OFFON

4P0OFFOFF

assembly

3.7.4 Note GCU Final Work

Reconfiguration Kit Twin VHF with Gantry Reconfiguration Kit Twin VHF mit Portal 121

3.7.4

3.7.4 Note GCU

Note GCU

Power cable GCU 3 [03068134-xx]

► Please check the connection of the GCU3 power cable with the connector X1up. (1) to ensure a cor

rect start-up of the machine.

NOTICE

Dismantling a Gantry

The connector X1up has to be disconnected from the GCU3, if the gantry is dismantled later on.