00195941-03-UM SiplaceCA-EN - 第19页

User Manual SIPLACE CA 1 Introduction Edition 08/2011 EN 19 1 Introduction This operating manual is desig ned as a source of information and re ference for those persons op - erating and setting up the CA series placemen…

Contents User Manual SIPLACE CA

Edition 08/2011 EN

User Manual SIPLACE CA 1 Introduction

Edition 08/2011 EN

1 Introduction

This operating manual is designed as a source of information and reference for those persons op-

erating and setting up the CA series placement machines.

Fig. 1.0 - 1 SIPLACE CA4 placement machine with SIPLACE Wafer System (SWS)

(1) SIPLACE CA4

(2) SIPLACE Wafer System (SWS)

The header of each chapter contains the

– release and

– software version

valid from this issue. 1

1 Introduction User Manual SIPLACE CA

1.1 Machine Description Edition 08/2011 EN

1.1 Machine Description

The SIPLACE CA placement systems are known for high configuration flexibility, placement per-

formance and precision. The placement machines of the SIPLACE CA series are available in two

variants:

– SIPLACE CA3, the placement machine with 3 gantries and

– SIPLACE CA4, the placement machine with 4 gantries.

The SIPLACE CA can place bare dies directly from the wafer, by using the flip chip or die attach

process, and can also place the entire SMD spectrum covered by the SIPLACE X machines. Two

placement variants are being used at the placement machine:

– the Collect&Place-method for highspeed placement of standard components

– the Pick&Place-method for highspeed placement of special components in the Fine Pitch

and Super Fine Pitch area

The SIPLACE is based on the well-proven hardware and software of the SIPLACE X machine.

Several changes in the hard and software permit operations on the SIPLACE CA running the

brand new designed SIPLACE Wafer System (SWS) with the same user interface for the SI-

PLACE Pro and station software. The placement machine is equipped with at least one SWS in

one of the four locations, to be able to place dies from the wafer. The Siplace CA can be operated

without a SWS and thus can be used like a X machine. This makes the components (dies) directly

available to the placement head, in so-called wafers. The SWS is available in the following variant:

– SWS 12 for wafers on wafer frames up to 15“

The gantries that are driven by linear motors can be positioned fast and precisely in X and Y di-

rection. There is a placement head on each gantry.

The moving head picks the components up from the waiting SWS and places them on the waiting

printed circuit board. This proven SIPLACE principle has many advantages:

– No downtime due to refilling or splicing

– safe pick up of even the smallest components

– no shifting of the components on the circuit board

– minimised travel range

High flexibility, economic efficiency and reliable setups are the guarantee for the high level of pro-

ductivity in the SIPLACE CA placement systems. Minimum down times increase utilization and

thus help to increase productivity. Even small 01005 components can be processed with the SI-

PLACE CA series.