00195941-03-UM SiplaceCA-EN - 第252页
4 Setting Up and Commissioning User Manual SIPLACE CA 4.2 Delivery Configuration and Transportati on of Placement Machine Edition 08/2011 EN 252 Forks across the PCB conveyor 4 4 Fig. 4.2 - 4 Contact surfaces - Forks acr…
User Manual SIPLACE CA 4 Setting Up and Commissioning
Edition 08/2011 EN 4.2 Delivery Configuration and Transportation of Placement Machine
251
4
Fig. 4.2 - 3 Contact surfaces - Forks parallel to the direction of PCB transport
(1) Contact surfaces for the forks of the fork-lift
4 Setting Up and Commissioning User Manual SIPLACE CA
4.2 Delivery Configuration and Transportation of Placement Machine Edition 08/2011 EN
252
Forks across the PCB conveyor 4
4
Fig. 4.2 - 4 Contact surfaces - Forks across the direction of PCB transport
(1) Contact surfaces for the forks of the fork-lift
User Manual SIPLACE CA 4 Setting Up and Commissioning
Edition 08/2011 EN 4.2 Delivery Configuration and Transportation of Placement Machine
253
WARNING 4
Before lifting the placement machine, observe the following points to avoid causing irreversible
damage to the machine:
– The distance between the forks must be between 800 and 900 mm. The attachment points
for the fork-lift truck can be seen in fig. 4.2 - 4
. The outer distance between the machine feet
is 1120 mm. Make sure you do not increase the distance between the forks so that the place-
ment machine is lifted under the sides of the machine frame, as this would distort the machine
frame.
When lifting the placement machine, make sure that the forks are loaded evenly. A firm sup-
port surface between the fork and the machine prevents the machine from tipping over when
lifted. This will also prevent a one-sided load on the machine feet, which would deform the
fixing of the machine feet. We recommend that a second person monitors the lifting of the ma-
chine and ensures that the placement machine does not tip over to one side when lifted by
the fork-lift truck.
4.2.4.4 Points that Must be Noted When Transporting the Machine
WARNING 4
When you are transporting the machine, make sure that all the feet are clear of the floor. If the
machine feet should drag along the floor during transportation or hit an obstacle, this could dam-
age the fixtures for the machine feet in the placement machine!