00195941-03-UM SiplaceCA-EN - 第317页
User Manual SIPLACE CA 4 Setting Up and Commissioning Edition 08/2011 EN 4.5 Setting Up the Placement Machine 317 4 Fig. 4.5 - 28 Setting the height for the outer machine feet (1) Sett ing screw M 24x2x12 0 for heigh t a…
4 Setting Up and Commissioning User Manual SIPLACE CA
4.5 Setting Up the Placement Machine Edition 08/2011 EN
316
4.5.17 Final Adjustment of the Placement Machine
Place the machine spirit level in the X and Y directions, on the sides of the PCB conveyor in
placement area 1 (see fig. 4.5 - 27
). The PCB conveyor width is preset:
Single conveyor 210 mm
Dual conveyor, track 1 100 mm
Dual conveyor, track 2 210 mm 4
Note: 4
When using a dual conveyor, the spirit level for adjustment needs to be always placed on the
outer sides of the placement machine, when measuring in the X direction.
Measure the distance between the top edge of the PCB conveyor belt and the floor. This dis-
tance should be 800 mm, 900 mm, 930 mm or 950 mm.
4
Fig. 4.5 - 27 Adjusting the placement machine in the X and Y directions
Use an open-ended wrench SW36 to adjust the setting screw M24x2x120 (item 1 in fig. 4.5 -
28) so that the spirit level does not deviate from its zero point when measuring the required
PCB conveyor height.
User Manual SIPLACE CA 4 Setting Up and Commissioning
Edition 08/2011 EN 4.5 Setting Up the Placement Machine
317
4
Fig. 4.5 - 28 Setting the height for the outer machine feet
(1) Setting screw M24x2x120 for height adjustment
(2) Outer machine foot
(3) Clamping piece
(4) M24x90 hexagon socket head screw
Check the required PCB conveyor height.
Once the placement machine has been correctly aligned, use the torque wrench to tighten
the hexagon socket-head screws M24x90 (item 4) to clamp the clamping pieces on all outer
machine feet (item 3).
4 Setting Up and Commissioning User Manual SIPLACE CA
4.5 Setting Up the Placement Machine Edition 08/2011 EN
318
4
NOTE 4
The tightening torque is 130 Nm. If you use a lower tightening torque, the placement machine
may tend to vibrate.
Unscrew the middle machine feet using a hook wrench 135 - 145 until they are seated firmly
on the ground.
Make sure that the middle machine feet are not unscrewed too far, otherwise they may mis-
align the placement machine.
4
Fig. 4.5 - 29 Aligning and locking the middle machine foot
Recheck the exact alignment of the placement machine with the machine spirit level.
Use the size 65 open-ended spanner to tighten the M24 lock nut (item 3).
4.5.18 Removing the Shipping Braces
– Remove all the shipping braces from the gantry axes.
(1) Spacer
(2) Middle machine foot
(3) M24 lock nut