00195941-03-UM SiplaceCA-EN - 第346页
5 Tasks on the Mach ine User Manual SIPLACE CA 5.4 Performing Inspections Edition 08/2011 EN 346 5.4.3 Checking the PCB Support s Check the position of the magnetic PCB supports on the lif ting table: – Make sure that …
User Manual SIPLACE CA 5 Tasks on the Machine
Edition 08/2011 EN 5.4 Performing Inspections
345
NOTE 5
Never tear the cover foil. This can cause problems with the cover foil pull-off. There is an in-
tegral blade (item 2) for easily cutting the on the 8 and 12 mm X tape feeder modules.
Check the multicolor status display (item 3 in fig. 5.4 - 1).
– If it lights up green, the feeder module is on standby.
– If it lights up orange, it is signaling a warning. The text of the warning appears on the LCD
display (item 4 in fig. 5.4 - 1
).
– If the status display lights up red, a malfunction has occurred. The error message will ap-
pear on the LCD display (item 3 in fig. 5.4 - 1
).
For a list of the LCD and status displays on the operating panel, refer to section 5.7
, page
359
. 5
If the status display is off, the cause may be as follows: 5
– The feeder module is not in the current setup.
– The feeder module is defective.
– The feeder module has been disabled (due to a drop in pressure, for example)
5.4.2 Splicing the Belts in Time
Note:
Make sure you splice on new tapes in good time, so that the feeders do not run empty. Oth-
erwise you will experience prolonged down times.
However, do not splice the tapes too early because if you wind the end of the old tape onto
the new reel after splicing, the reel holding the new tape may become overfilled and the tape
will slip off the reel and become tangled up. This will again result in pickup errors and pro-
longed down times. 5
5 Tasks on the Machine User Manual SIPLACE CA
5.4 Performing Inspections Edition 08/2011 EN
346
5.4.3 Checking the PCB Supports
Check the position of the magnetic PCB supports on the lifting table:
– Make sure that the PCB supports do not collide with components on the underside of the
PCBs.
– In addition, make sure that the PCB supports do not collide with the PCB conveyor pan-
els.
– Use only those PCB supports described in section 7.10
, page 474.
5.4.4 Mount for additional Tape Reel (X-Series)
5
Fig. 5.4 - 2 Mount for additional Tape Reel (X-Series)
(1) Mount for additional tape reel [00141217-xx]
(2) Mounting device for the support
5
Max. 60 mm
User Manual SIPLACE CA 5 Tasks on the Machine
Edition 08/2011 EN 5.4 Performing Inspections
347
X-series feeder modules can process component tapes without problems if the lateral offset be-
tween the feeder module and the tape reel does not exceed 60 mm. If a predefined setup means
that the maximum permitted offset cannot be maintained, we recommend that you use the mount
for an additional tape reel (item 1). Simply insert the mount into the holder (item 2) and push it until
the offset is less than the maximum permitted value of 60 mm. The component trolley has 5 hold-
ers in total. Each tape reel mount can hold 2 tape reels, which means that up to ten 15" (381 mm)
reels can be positioned above the tape container.