00195941-03-UM SiplaceCA-EN - 第364页

5 Tasks on the Mach ine User Manual SIPLACE CA 5.8 Changing Setups Edition 08/2011 EN 364 5.8.2 Changing Setup s at the SWS  Check if the o rientation of the wafer locking bar fits with the relevant wafer size ( 10,5&qu…

User Manual SIPLACE CA 5 Tasks on the Machine

Edition 08/2011 EN 5.8 Changing Setups

363

5.8 Changing Setups

5.8.1 Changing Setups at the Placement Machine

5.8.1.1 Printing Setup Changeover Instructions Before Setup Changes

Before a change of setup, print out the conversion instructions on the printer for the SIPLACE Pro

computer as described in the "SIPLACE Pro" manual or in the online help.

5.8.1.2 What You Should Note when Changing the Feeder Modules

 Handle the feeder modules carefully when you insert them into or remove them from the com-

ponent feeder table. Do not hit the X feeder against the centering bar (see item 5 in fig. 5.5 -

3, page 353) of the changeover table.

 Vacuum the supporting surfaces of the feeder modules and clean the surface of the compo-

nent feeder table when necessary according to the instructions in the Preventive Mainte-

nance Manual.

 Remove loose components using a brush or a vacuum cleaner with a suitable nozzle.

CAUTION 5

Avoid removing components from the component table with your fingers. You may hurt your-

self with tiny splinters of metal.

5 Tasks on the Machine User Manual SIPLACE CA

5.8 Changing Setups Edition 08/2011 EN

364

5.8.2 Changing Setups at the SWS

 Check if the orientation of the wafer locking bar fits with the relevant wafer size (10,5" oder

10,8" bei 8" Wafern) (see fig. 3.7 - 19

, page168).

NOTE 5

During commissioning, the SWS is configured according to the required wafer size (8" or 12")

and thickness of the wafer frame. Adapting the SWS to other sizes and thicknesses is de-

scribed in the service manual.

 Adjust the feeder plate for the wafer magazine (8" or 12") and insert the new magazine. Make

sure the magazine has the correct configuration.

 Check the needle configuration at the die ejector (see section 5.2.5, page 338).

 Check, if the flip unit is equipped with the appropriate tools and nozzles (see section 5.2.6,

page 342).

 Load or compile the required product (see software guide).

User Manual SIPLACE CA 5 Tasks on the Machine

Edition 08/2011 EN 5.9 Avoiding Track Errors

365

5.9 Avoiding Track Errors

5.9.1 General

 Make sure that the areas around the feeder modules are clean and that there are no loose

components in the feeder area or under the feeder modules.

 Refill promptly with components.

 Splice the tapes early. This generally means that you are to prepare the splicing material

when there is still approximately 1.5 m of tape on the reel.

 Handle the feeder modules carefully when you insert them into or remove them from the com-

ponent feeder table as these are high-precision devices.

 For X feeder modules, lower the pickup window since it can easily be damaged when raised.

NOTE 5

A raised pickup window leads to noticeably impaired pickup quality.

 Please check whether the pickup position is set correctly for the feeder modules.