88242361-04-01 Vol 1 DEK TQ TECHNICAL REFERENCE (1) - 第26页
3 COVERS AND PANELS 3.2 PANEL REMOVAL 26 TECHNICAL REFERENCE MANUAL DEK TQ 04/2021 3.2.2 Front Panel To remove the front panel, carry out the following: 1. Open the front and paste dispenser covers. 2. Using a 4mm Allen …
3 COVERS AND PANELS
3.2 PANEL REMOVAL
TECHNICAL REFERENCE MANUAL DEK TQ 04/2021 25
3.1.2 Rear Cover
5
4
3
2
1
View on Rear
1 Rear Upper Panel 4 Right Hand Safety Panel
2 Rear Lower Panel 5 Right Hand Top Side Panel
3 Right Hand Lower Side Panel
3.2 PANEL REMOVAL
NOTE
When refitting the panels, ensure that they are fitted correctly and securely.
3.2.1 Earth Bonding
The opening covers and the safety panels are mechanically bonded to the machine earth point.
The machine panels are electrically bonded using an earth stud on the panel connected to a green
and yellow insulated cable. Occasionally an earth cable must be removed so that the panel may be
moved away from the machine to gain more access.
Using an 8mm spanner, remove the two earth cable securing nuts and washer to detach the earth
cable from the panel.
Refit the washer and two nuts on to the earth stud for safe keeping.
When refitting the cable, ensure they are secured (tightly) onto a clean surface.
3 COVERS AND PANELS
3.2 PANEL REMOVAL
26 TECHNICAL REFERENCE MANUAL DEK TQ 04/2021
3.2.2 Front Panel
To remove the front panel, carry out the following:
1. Open the front and paste dispenser covers.
2. Using a 4mm Allen key, undo the two captive securing screws at the top of the panel.
3. To remove the panel, pull the top of the cover away from the machine and lift the panel
upwards to clear the locating tabs. Take care not to damage the earth cable.
3.2.3 Safety Panels
Safety panels are fitted to the side panels to protect personnel from access to the board entry/exit
ports.
NOTE
The safety panels can be adjusted to accommodate the thickness of the product.
To remove or adjust the safety panel (1), undo the four captive securing screws (2).
2
1
3 COVERS AND PANELS
3.2 PANEL REMOVAL
TECHNICAL REFERENCE MANUAL DEK TQ 04/2021 27
3.2.4 Top Panel
To remove the panel, carry out the following:
1. Using a 4mm Allen key, undo the two captive securing screws (2).
2
1
2. Using the handle (1), slide the top panel rearwards about 30cm to access the earth cable.
3. Disconnect the cable from the earth stud.
4. Slide the panel fully off the back of the machine taking care as the panel weight is 5.2kg.
3.2.5 Rear Upper Panel
To remove the panel, carry out the following:
1. Using a 4mm Allen key, undo the four captive securing screws (1).
2
1
1
2. Using the handles (2), lift the panel upwards to clear the locating tabs before removing from
the machine. Take care not to damage the earth cable.