SIPLACE X-Series (SIPLACE X-Series S, from SC 708.1) Edition 05/2015 EN User manual - 第210页
3 Technical data and assemblies User manual SIPLACE X-Series 3.10 Component trolley From software version 708.1 Version 05/2015 210 3.10.5 Dimensions of SIPLACE X-Series component trolley 3 Fig. 3.10 - 5 Dimensions of th…
User manual SIPLACE X-Series 3 Technical data and assemblies
From software version 708.1 Version 05/2015 3.10 Component trolley
209
3.10.4 Fiducials on the SIPLACE X-Series component trolley
3
Fig. 3.10 - 4 Fiducials on the SIPLACE X-Series component trolley
(1) Fiducials on the component trolley
Once the SIPLACE X-Series component trolley has been docked in, the machine measures the
fiducials on the component trolley.
For components with an edge length of less than 0.5 mm, i.e. 0402 components and smaller, the
position of the component is determined with the tape pocket before the first component is picked
up.
3 Technical data and assemblies User manual SIPLACE X-Series
3.10 Component trolley From software version 708.1 Version 05/2015
210
3.10.5 Dimensions of SIPLACE X-Series component trolley
3
Fig. 3.10 - 5 Dimensions of the SIPLACE X-Series component trolley; all dimensions in millimeters
User manual SIPLACE X-Series 3 Technical data and assemblies
From software version 708.1 Version 05/2015 3.10 Component trolley
211
3.10.6 SIPLACE X-Series changeover table
The front slider guides of the feeder modules are placed on the insertion aid (item 1 in fig.
3.10 - 6
). When pushed in, the slider guides of the
feeder module (item 12 and 13 in fig. 3.9 - 2
, page 177) slide on the guide profile (item 2 in fig.
3.10 - 6
) up to the stop rail (item 4 in fig. 3.10 - 6). A centering hole (item 5 in fig. 3.10 - 6) on the
stop rail accommodates the X feeder module centering pin "front" (item 4 in fig. 3.9 - 1
, page 176).
At the same time, the changeover table locking latch (item 1 in fig. 3.10 - 7
, page 212) engages
onto the locking roller (item 1 in fig. 3.9 - 1
, page 176) of the feeder module. The centering pin
"rear" (item 12 in fig. 3.9 - 1
, page 176) on the upper side of the feeder module is accommodated
by the recess in the centering bar (item 3 in fig. 3.10 - 6
).
3
Fig. 3.10 - 6 Changeover table, SIPLACE X-Series, rear view
(1) Insertion aid
(2) Guide profile (Ω profile)
(3) Centering bar for holding the "back" centering pin for X feeder modules
(4) Stop bar
(5) Centering holes
(6) Contact for switching the safety switch of the EMERGENCY STOP circuit
(7) Hand guard