SIPLACE X-Series (SIPLACE X-Series S, from SC 708.1) Edition 05/2015 EN User manual - 第319页
User manual SIPLACE X-Series 5 Working with the machine From software version 708.1 Version 05/2015 5.15 Docking the component trolley in or out 319 5.15 Docking the component trolley in or out 5.15.1 Safety instructi on…
5 Working with the machine User manual SIPLACE X-Series
5.14 Refilling components From software version 708.1 Version 05/2015
318
5.14 Refilling components
The online help contains information on refilling components with and without barcodes.
With tape feeder modules, make sure that you always splice on a new tape early enough so
that the feeder modules do not run out of components.
However, do not splice the tapes too early because if you wind the tape onto the new reel
after splicing the end of the old tape, the reel with the new tape may be overfilled. The tape
could then slip off the reel and become tangled. Under certain circumstances, this could
cause pick-up errors and prolonged down times.
User manual SIPLACE X-Series 5 Working with the machine
From software version 708.1 Version 05/2015 5.15 Docking the component trolley in or out
319
5.15 Docking the component trolley in or out
5.15.1 Safety instructions for docking component trolleys in and out
Also follow the safety instructions given in section 2.5.11, page 78.
5
In addition, the component trolley can only be docked in if the protective
covers are closed.
There is a button at each location (1,2,3 and 4). The safety concept for the component trolley
changeover specifies that the operator should push this button at the relevant machine location,
to dock or undock the component trolley.
WARNING
DANGER OF CRUSHING!
Risk of crushing when docking and undocking the component trolley.
Always dock/undock the component trolley alone.
When docking and undocking, make sure that there are no body limbs in the travel
area of the component trolley.
5 Working with the machine User manual SIPLACE X-Series
5.15 Docking the component trolley in or out From software version 708.1 Version 05/2015
320
5
Fig. 5.15 - 1 Safety instructions for docking the component trolley in or out (example of SIPLACE X2 S / X3 S / X4 S
shown)
In addition, the component trolley can only be docked in if the protective
covers are closed.
(1) Button for docking and undocking the component trolley at location 1
(T) Direction of PCB transport
5.15.2 Docking out the component trolley
Press the button on the respective machine location until the component trolley is completely
undocked.
Swivel the two handles up (item 1 in fig. 5.15 - 2).
(1)