M1series_ServiceManual_e - 第11页

1 Installation 1-3 How to Hoist the Machine Be sure to use the bolts wh en hoisting the machine. ■ Recommended Bolt Size ● Type 1 (M20 x P2.5) ● Type 2 (M20 x P2.5) [Unit = mm] M x P D d d1 L2 L3 S T L R H B C Type1 Type…

1 Installation

1-2

Installation of Machine

Environmental Requirements

Install the machine at the place where the below conditions are met.

Do not do tasks, such as moving the machine or connecting the machine with the main switch ON to

prevent electric shock.

Warning

■ Ambient Temperature: Accuracy assurance 23 +/-2 degrees centigrade

Operation assurance 5 to 40 degrees centigrade

(The average over a period of 24 hours does not exceed 35 degrees C.)

■ Relative Humidity: 45 to 60 percent, non-condensing

■ Atmosphere: Dust and corrosive gas free

■ Floor: Floor must be flat and sturdy enough for freedom from vibration during

operation.

■ Power Requirements: 200 VAC +/- 10%, three phase, 50/60 Hz

* 208/220/230/240/380/400/415/440 VAC with optional power

transformer

Power consumption: 2 kW

Capacity: 5 kVA

Leakage current: 100mA or less

* Power and ground the machine independently of other machines which may be a

noise source, such as a compressor, welding machine, or reflow soldering machine

with magnetic contacts.

1 Installation

1-3

How to Hoist the Machine

Be sure to use the bolts when hoisting the machine.

■ Recommended Bolt Size

● Type 1 (M20 x P2.5)

● Type 2 (M20 x P2.5)

[Unit = mm]

M x P D d d1 L2 L3 S T L R H B C

Type1 Type2

20ｘ 2.5

25 48 62 20 28 37 32 16 90 98 2 12 17 19.8

1 Installation

1-4

■ How to Hoist

Use the bolts, wires, and the arm as the following diagram shows.

Bolt

Arm

Front View

Arm

Side View

NOTE: Be sure to use the arm to prevent the wire from touching the machine.