KE-2030使用说明书 - 第122页
4 – 23 4.3.3 Paste This command inser ts the dat a which w as cut or copied int o the mem ory buffer at or befor e which the cursor is located. Aft er you select the [Cut] command, the f ollowing dialog box appears on th…
4 – 22
4.3 Editing
When you select the [Edit] command on the menu bar, the following commands menu
appears on the screen.
Selecting the range of data
To cut or copy data, select the data range to be copied or cut in advance.
When you drag the trackball, the lines to be selected are highlighted.
When you press the up or down arrow key while holding the SHIFT key of a keyboard,
the lines to be selected are highlighted.
Every time you press the Page UP key or Page Down key while holding down the
SHIFT key, a page (lines displayed on the screen) is selected one by one
sequentially.
4.3.1 Cut
This command deletes the line(s) which is (are) selected and highlighted. The
deleted data cannot be used with the [Paste] command.
After deletion, data preceded by the deleted data is moved up to the deleted line(s).
If you do not specify the data range to be cut, this command is disabled.
4.3.2 Copy
This command loads the data which is selected and highlighted into the memory
buffer. To paste it in another data, execute the [Paste] command.
4 – 23
4.3.3 Paste
This command inserts the data which was cut or copied into the memory buffer at or
before which the cursor is located.
After you select the [Cut] command, the following dialog box appears on the screen.
When you specify the “X pitch” and “Y pitch”, you can execute the incremental copy
function which copies data with adding or subtracting the specified values to/from
the X placement position and Y placement position.
After executing the [Paste] function for Placement data, all of the component IDs are
set to “#” and data is pasted.
If there is no data in the memory buffer, this command is disabled.
① No. of copies: Specifies the number of times for copying data. The default
value is “1”.
② X pitch: Specifies the amount to increment or decrement the placement
position in the X direction. The default value is “0.00”.
③ Y pitch: Specifies the amount to increment or decrement the placement
position in the Y direction. The default value is “0.00”.
④ OK: Executes the “Paste” command.
⑤ Cancel: Cancels the “Paste” command.
Example of the paste result
When normally executed
例
)
Component IDs X Y Angle Component name
R1 5.00 10.00 45.00 1608-A
R2 10.00 10.00 0.00 1608-A
No. of copies 3 X Pitch: 0.50
Y Pitch: 1.00
# 5.50 11.00 45.00 1608-A
# 10.50 11.00 0.00 1608-A
# 6.00 12.00 45.00 1608-A
# 11.00 12.00 0.00 1608-A
# 6.50 13.00 45.00 1608-A
# 11.50 13.00 0.00 1608-A
• The copied block is inserted above the specified line.
• All of the Component IDs are set to “#”.
• The input focus is located at the first inserted Component ID.
4 – 24
When an error occurs
In the following cases, an error occurs, and the machine displays the respective error
dialog box as shown below.
① When the maximum number of data records exceeds the input limit
− OK: Cancels the copy operation. No data is copied.
② When the placement position exceeds the PWB or circuit layout
− OK: Continues the copy operation. The range over mark is appended to an
error data record.
− Cancel: Cancels the copy operation.