00193922-01 - 第202页

4 Setting up and commissioning User Manual SIPLACE HF Series 4.5 Setting up the placement machine Software Version SR.505.x x 05/2004 US Edition 202 (4) M24x9 0 hexa gon sock et hea d screw Æ Check the requi red PCB tr a…

100%1 / 358
User Manual SIPLACE HF Series 4 Setting up and commissioning
Software Version SR.505.xx 05/2004 US Edition 4.5 Setting up the placement machine
201
NOTE
If the machine is set to a PCB transport height of 830 mm and the component trolley docking unit
is fitted in the front position (see Fig. 4.5 - 24
), then the hexagon head screw M24 x 80 (item 1 in
Fig. 4.5 - 24
) is covered by the cylinder air connection (item 3 in Fig. 4.5 - 24) for the component
trolley docking unit.
Æ You should therefore remove the air connection (item 4 in Fig. 4.5 - 24) in order to carry out the
adjustment.
4
Fig. 4.5 - 22 Adjusting the height of the machine feet
(1) Hexagon head screw M24x80 for adjusting the height
(2) Machine foot
(3) Clamp
4 Setting up and commissioning User Manual SIPLACE HF Series
4.5 Setting up the placement machine Software Version SR.505.xx 05/2004 US Edition
202
(4) M24x90 hexagon socket head screw
Æ Check the required PCB transport height.
Æ If the placement machine has been aligned, use the size 19 Allen key to tighten the hexagon
socket head screws M24x90 (Pos. 4) for holding the clamps on all the machine feet (item 3).
Æ Unscrew the "HS50" machine foot until it is seated firmly on the ground.
Æ Make sure that you do not unscrew the "HS50" machine foot so far that the machine is no
longer adjusted.
4
4
4
4
4
4
4
Fig. 4.5 - 23 Aligning and locking the "HS50" machine foot
(1) spacer
(2) "HS50" machine foot
(3) M24 lock nut
4
Æ Use the spirit level to ensure that the placement machine is precisely aligned.
Æ Fix the air connection to the cylinder of the docking unit if you previously removed it in order to
adjust the PCB transport height of 830 mm.
Æ Use the size 65 open-ended spanner to tighten the M24 lock nut (item 4).
User Manual SIPLACE HF Series 4 Setting up and commissioning
Software Version SR.505.xx 05/2004 US Edition 4.5 Setting up the placement machine
203
4.5.15.1 Removing the air connection on the component trolley docking unit
4
Fig. 4.5 - 24 Air connection on the cylinder of the component trolley docking unit
4
(1) M24 x 80 hexagon head screw
(2) Component trolley docking unit
(3) Cylinder
(4) Air connection, hexagon nut M10
Æ Use the size 17 open-ended spanner to remove the air connection on the docking unit.