00197551-01_MM_CPP-CP-Twin_Kunde_en - 第22页

Maintenance tasks for CPP Overview of Lubrication Points 22 Maintenance Manual SIPLACE Placement Heads CPP, C&P20, Twin 3.4 3 . 4 O v e r v ie w o f L u b r ic a t io n P o in t s Overview of Lubrication Points Drive…

100%1 / 92
Maintenance tasks for CPP
Preparatory Steps
Maintenance Manual SIPLACE Placement Heads CPP, C&P20, Twin 21
Preparing the Placement Head
► Dismantle the placement head and remove it from the placement machine. For details, refer to the
service manual for your machine.
Use the FHE function if possible.
► Fit the placement head onto the head mount.
Dismantling the Front Plate
► Dismantle the front plate. For details, refer to the "Service manual CPP".
Multipette
Multipette
► Prepare the multipette. For more information about this, read section "9 Handling the Multipette"
[ ➙ 89]. Also observe the following instructions:
Color-coding of dosage devices and lubricants
► Fit the protective cap onto the component sensor for
the placement head.
CAUTION
Do not combine lubricants!
Contamination (combination) of lubricants can affect the service life of the bearings!
► Only use the combitip specifically marked for each lubricant, to avoid combining the lubri-
cants.
Color Lubricant Application
Black Black combitip
Klüberalfa DH 3-100
Driver bearing
Blue Blue combitip
Lubcon Thermoplex ALN 1001/00 50 ml
Segment guide/Z linear guide
Yellow Yellow combitip
Klüber oil GEM 1 220 N
Support roller
Green Green combitip
Isoflex Topas NCA 5051
Star bearing
Maintenance tasks for CPP
Overview of Lubrication Points
22 Maintenance Manual SIPLACE Placement Heads CPP, C&P20, Twin
3.4
3.4 Overview of Lubrication Points
Overview of Lubrication Points
Driver bearing
1 x 1 µl Klüberalfa DH 3-100 (black combitip)
per driver bearing
DP segment guide
2 x 2 µl Lubcon Thermoplex ALN 1001/00 (blue combitip)
per ball groove at each segment
Z linear guide
2 x 4 µl Lubcon Thermoplex ALN 1001/00 (blue combitip)
per ball groove
Maintenance tasks for CPP
Overview of Lubrication Points
Maintenance Manual SIPLACE Placement Heads CPP, C&P20, Twin 23
Support roller
1 x 1 µl Klüber oil GEM 1 220 N (yellow combitip) on the
supporting roller
NOTICE!
Depending on the head version there might be no yellow
dot at the position marked in the picture and no service
drilling for oiling the support roller. It is not necessary to
oil the support roller in this case.
Star bearing
24 x 2 µl Isoflex Topas NCA 5051 (green combitip) into
star bearing