00197551-01_MM_CPP-CP-Twin_Kunde_en - 第23页
Maintenance tasks for CPP Overview of Lubrication Points Maintenance Manual SIPLACE Placement Heads CPP, C &P20, Twin 23 Support roller 1 x 1 µl Klüber oil GEM 1 220 N (yellow combitip) on the supporting roller NOTIC…
Maintenance tasks for CPP
Overview of Lubrication Points
22 Maintenance Manual SIPLACE Placement Heads CPP, C&P20, Twin
3.4
3.4 Overview of Lubrication Points
Overview of Lubrication Points
Driver bearing
1 x 1 µl Klüberalfa DH 3-100 (black combitip)
per driver bearing
DP segment guide
2 x 2 µl Lubcon Thermoplex ALN 1001/00 (blue combitip)
per ball groove at each segment
Z linear guide
2 x 4 µl Lubcon Thermoplex ALN 1001/00 (blue combitip)
per ball groove
Maintenance tasks for CPP
Overview of Lubrication Points
Maintenance Manual SIPLACE Placement Heads CPP, C&P20, Twin 23
Support roller
1 x 1 µl Klüber oil GEM 1 220 N (yellow combitip) on the
supporting roller
NOTICE!
Depending on the head version there might be no yellow
dot at the position marked in the picture and no service
drilling for oiling the support roller. It is not necessary to
oil the support roller in this case.
Star bearing
24 x 2 µl Isoflex Topas NCA 5051 (green combitip) into
star bearing
Maintenance tasks for CPP
Performing Maintenance Tasks 3.5.1 Replacing the Pressure Control Valve
24 Maintenance Manual SIPLACE Placement Heads CPP, C&P20, Twin
3.5
3.5 Performing Maintenance Tasks
Performing Maintenance Tasks
3.5.1
3.5.1 Replacing the Pressure Control Valve
Replacing the Pressure Control Valve
Replacin g the Pres sure Contr ol Valve
Replacing the Pressure Control Valve
➢ The placement head must be removed for this maintenance task.
► Replace the pressure control valve. Read the service manual for your placement head for more in-
formation.
3.5.2
3.5.2 Maintenance Tasks on Vacuum-Conducting Parts
Maintenance Tasks on Vacuum-Conducting Parts
Removing the Screwed Joint of the Silencer
NOTICE
Recommendation
We recommend that you have an additional pressure control valve available, so that this can
be easily replaced during head maintenance.
The actual cleaning of the removed pressure control valve can be performed later on.
► For more information about this, read section "6 Maintenance Tasks for Pressure Control
Valve" [ ➙ 65].
NOTICE
Vacuum test
► When carrying out the following tasks, especially check the segments that were noticeable
during the vacuum test.
CAUTION
Checking the silencer
Technical information "Defective silencer at CPP head" [DE: TI2013-04D01] [EN:
TI2013-04E01].
► Check the silencer on the problems described in the technical information and replace it, if
needed.
► Remove the screwed joint (1). This task must be car-
ried out by authorized personnel. For removal and in-
stallation details, read the Service manual.
► Take out the holding circuit housing together with the
silencer.