00197551-01_MM_CPP-CP-Twin_Kunde_en - 第35页

Maintenance Tasks for C&P20/A/M/P Head Maintenance Manual SIPLACE Placement Heads CPP, C &P20, Twin 35 4 4 M a in t e n a n c e T a s k s f o r C & P 2 0 / A / M / P H e a d Maintenance Tasks for C&P20/A/…

Maintenance tasks for CPP

Final Work 3.5.11 Cleaning the Component Sensor

34 Maintenance Manual SIPLACE Placement Heads CPP, C&P20, Twin

3.6

3.6 Final Work

Final Work

Attaching the maintenance label

Fitting the front plate

► Remove the front plate. For details, refer to the service manual.

Fitting the Placement Head

► Fit the placement head back onto the gantry. Read the service manual for your machine first.

► Remove the protective cap from the component sensor.

► Switch the placement machine on at the main switch.

► Perform a reference run.

► If you have replaced the vacuum hoses on the DP drive, perform a vacuum check. If there are still

problems, have the hold circuit checked by the SIPLACE service team.

► Calibrate the placement head, preferably using the FHE function. Read the service manual for your

machine first.

► For SW703.02 and higher only: Reset the maintenance cycle counter for the corresponding assem-

blies.

► Remove any label which may still be present from the

placement head.

► Remove any adhesive residues and clean the area.

► Attach the label and enter the date and, if required,

the meter count, depending on how you determine

your maintenance intervals.

Maintenance Tasks for C&P20/A/M/P Head

Maintenance Manual SIPLACE Placement Heads CPP, C&P20, Twin 35

4 Maintenance Tasks for C&P20/A/M/P Head

Maintenance Tasks for C&P20/A/M/P Head

CAUTION

Do not get the heads mixed up!

Unless otherwise specified, all references made apply equally to the C&P20, C&P20 A,

C&P20 M and C&P20 P head.

► Maintenance of the C&P20, C&P20 A, C&P20 M and C&P20 P heads is largely identical.

Any relevant differences will be mentioned explicitly.

► The C&P20 M is only used with CA and Micron machines.

NOTICE

Example

All tasks are described using the example of a C&P20 A head. The procedure is the same for

other C&P20 variants. Any relevant differences will be mentioned explicitly.

Maintenance Tasks for C&P20/A/M/P Head

Differences Between C&P20, C&P20 A, C&P20 M and C&P20 P

36 Maintenance Manual SIPLACE Placement Heads CPP, C&P20, Twin

4.1

4.1 Differences Between C&P20, C&P20 A, C&P20 M and C&P20 P

Differences Between C&P20, C&P20 A, C&P20 M and C&P20 P

CP20 Differenti ation

Differentiation of the C&P20 head variants

The C&P20/A/M and the C&P20 P head differ in many details. They are easily identified by the following

features:

1. The C&P20 P can be identified by the fan. This fan is not present on the C&P20/A/M heads.

2. The component sensor is flatter and wider on the C&P20 P than on the C&P20/A/M.

CAUTION

Do not confuse the different C&P20 head variants.

► Parts from the C&P20/A/M head can not usually be used for the C&P20 P head (and vice

versa)!