00197551-01_MM_CPP-CP-Twin_Kunde_en - 第58页
Maintenance Tasks for C&P20/A/M/P Head Performing Maintenance Tasks 4.6.11 Checking/Replacing the Switc hing Disk 58 Maintenance Manual SIPLACE Placement Heads CPP, C&P20, Twin 4.6.11 4 . 6 . 1 1 C h e c k in g /…
Maintenance Tasks for C&P20/A/M/P Head
4.6.10 Replacing the Filter Disks Performing Maintenance Tasks
Maintenance Manual SIPLACE Placement Heads CPP, C&P20, Twin 57
Replacing the Filter Disks
Remove the filter disks (example of C&P20 A shown)
► Place the tool in front of the collar and press the guid-
ance sleeve against the collar.
► Turn the handle a quarter clockwise.
► Remove the tool.
► Make sure the filter disk has been removed complete-
ly.
► Remove the filter disk from the tool.
Fit the filter discs (example of C&P20 A shown)
► Insert the new filter disk into the tool.
► Press the filter disk centrally onto the collar.
The filter disks must engage audibly!
► Visually check the correct position of the filter disk.
The filter disk must be fitted straight on the DP drive!
Maintenance Tasks for C&P20/A/M/P Head
Performing Maintenance Tasks 4.6.11 Checking/Replacing the Switching Disk
58 Maintenance Manual SIPLACE Placement Heads CPP, C&P20, Twin
4.6.11
4.6.11 Checking/Replacing the Switching Disk
Checking/Replacing the Switching Disk
NOTICE
Not on C&P20 P
This maintenance task is not required for the C&P20 P.
► Check whether the switching disks are damaged or
broken (e.g. scratches or discoloration of the black
surface). Also check whether neighboring switching
disks have the same height. Differences in height are
an indication of damage.
► If a switching disk is damaged, carefully remove it (1).
► Use your thumb to press from below against the seg-
ment so that the segment is not damaged when you
remove it.
► Fit the new switching disk onto the segment so that
the pin (3) and groove (2) engage with one another.
► Use a suitable sleeve (in this case a pen cap) to press
the switching disk onto the segment. The nontrans-
parent switching disk must engage audibly.
► Also check whether the new and neighboring switch-
ing disks have the same height.
Maintenance Tasks for C&P20/A/M/P Head
4.6.12 Cleaning the Component Sensor Performing Maintenance Tasks
Maintenance Manual SIPLACE Placement Heads CPP, C&P20, Twin 59
4.6.12
4.6.12 Cleaning the Component Sensor
Cleaning the Component Sensor
CAUTION
Prisms, cleaning sticks
► Take care not to damage the component sensor prisms.
► Make sure that you do not use the cleaning sticks soaked in oil from cleaning the sleeves.
Always use a new cleaning stick!
Cleaning the component sensor (C&P20/A/M)
Cleaning the component sensor (C&P20 P)
► Remove the protective cover from the component
sensor.
► Clean the prisms of the component sensor with a
cleaning stick soaked in ethanol.
► Refit the protective cover on the component sensor.