ServiceInstruction_Vision XP - 第25页
Vision XP+ V AC Page 21 2 Maintenance 2.5 Process chamber Operating Instructions V ersion 1.5 2.5.5 Cleaning the Guide Rails for the Sheet Metal Cov ers The guide rails for the s heet metal cover are located at the inlet…
Page 20 Vision XP+ VAC
2 Maintenance
2.5 Process chamber
Operating Instructions
Version 1.5
2.5.4 Cleaning of coated nozzle fields (option)
Water-based medium or adhesive:
Solvent-based adhesives and oil-containing media:
Fig. 2-14 Cleaning of coated nozzle fields
Consumable:
• soft brush
Procedure:
1. Cleaning should be done with
warm water or soapsuds, but
the soapsuds has to be rinsed
with a lot of water subsequently.
Note!
Please use as auxiliary means for
mechanical removal a soft brush
and just a little pressure.
Fig. 2-15 Cleaning of coated nozzle fields
Consumable:
• soft brush
• acetone or Appropriate cleaning
agent
Procedure:
1. Cleaning should be done with
Acetone or Appropriate clean-
ing agent. Please use soft
brush and only just a little
pressure.
Note!
Cleaned surfaces have to be rinsed
with water subsequently to restore
the original characteristics.
Note!
Never use high-pressure cleaner as the water-repellent characteristics of
the coating will be damaged through this.
Vision XP+ VAC Page 21
2 Maintenance
2.5 Process chamber
Operating Instructions
Version 1.5
2.5.5 Cleaning the Guide Rails for the Sheet Metal Covers
The guide rails for the sheet metal cover are located at the inlet and the out-
let.
Fig. 2-16 Cleaning the Guide Rails
Consumable materials:
• Oven cleaner
• Rags
Procedure:
1. Raise the process chamber as
far as it will go. Set width adjust-
ment to the maximum value and
move the center support to the
middle.
2. Unscrew the sheet metal cover
(A) and pull it out.
3. Clean the groove in the top (B)
and bottom (C) guide rails with
a screwdriver, rags and oven
cleaner.
A
B
C
Page 22 Vision XP+ VAC
2 Maintenance
2.5 Process chamber
Operating Instructions
Version 1.5
2.5.6 Cleaning the Curtains
Fig. 2-17 Bottom Curtains
Fig. 2-18 Top curtains (2-part)
Fig. 2-19 Push the clips up with prying tool
Consumable materials:
• Oven cleaner
• Rags
• Prying tool
Procedure:
1. Raise the process chamber.
2. Lift the curtains out of the sys-
tem along with the mounting
bracket.
3. Clean all curtains, the mounting
bracket and the interior of the
process chamber with oven
cleaner and a rag.
If the curtains are excessively dam-
aged they must be replaced.
Procedure:
1. Push up the clips at the left and
right-hand sides of the mount-
ing rail with the prying tool.
2. Remove the old curtain.
3. Insert the new curtain.
4. Replace the clips.