EdisonStandardOwnersManual-RevA-20170818B - 第111页
Edison Printer User Manual (Part Number 1023838) P RINTER O PERATIONS Rev. A 111 Copyright © 2017 ITW EAE All rights reserved. No part of the contents of this manual ma y be reproduced, copied or transmitted in any form …
PRINTER OPERATIONS Edison Printer User Manual (Part Number 1023838)
110 Rev. A
Copyright © 2017 ITW EAE
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of ITW EAE, unless for purchaser's personal use.
Figure 96. Setup Screen.
5.5.2.2. Unload Stencil
This changeover task positions the printer components and displays the steps required for
successfully unloading the currently loaded stencil (including cleaning and removing squeegee
blades). Edison screens prompt the user with the
appropriate tasks (Figure 97).
Figure 97. Unload Stencil screen and steps.
Edison Printer User Manual (Part Number 1023838) PRINTER OPERATIONS
Rev. A 111
Copyright © 2017 ITW EAE
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of ITW EAE, unless for purchaser's personal use.
5.5.2.2.1. Remove Blades
1. Open the quick-release the front blade to the holder (Figure 98).
a. Slide the blade out of the holder.
b. Clean the blade over the stencil.
2. Repeat steps for the rear blade.
4. Remove the stencil by sliding it out and clean. Required to access the worknest area for tooling
removal / change.
Warning!
Print media contains lead and is hazardous to your health and the
environment.
Review the material safety data sheet before use.
Always wear protective gloves and safety glasses when
handling printing media.
Dispose of all waste material according to manufacturer’s
instructions.
Failure to comply could result in personal injury and/or damage to
the environment.
Warning!
Blade edges are sharp and can cut. Handle blades with care. Failure
to comply may result in injury.
Figure 98. Open quick-release and remove front blades. Note that hands should be gloved.
PRINTER OPERATIONS Edison Printer User Manual (Part Number 1023838)
112 Rev. A
Copyright © 2017 ITW EAE
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of ITW EAE, unless for purchaser's personal use.
5.5.2.3. Remove Tooling
Navigate to Remove Tooling to position
printer components (Figure 99). The
screen displays the steps required for
removing any tooling from the worknest.
Figure 99. Remove tooling screen.