EdisonStandardOwnersManual-RevA-20170818B - 第73页
Edison Printer User Manual (Part Number 1023838) P ROCESS P ROGRA M C REATION Rev. A 73 Copyright © 2017 ITW EAE All rights reserved. No part of the contents of this manual may be reproduced, copi ed or transmi tted in a…
PROCESS PROGRAM CREATION Edison Printer User Manual
72 Rev. A
Copyright © 2017 ITW EAE
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of ITW EAE, unless for purchaser's personal use.
Dedicated work holder
Tooling Block/pins
Grid Automatic
Grid Manual
In the Vacuum Mode section, choose between:
Off
Snug
Full
On except print
In the Flipper Mode section, choose between:
Off
Snug
Full
Figure 46. Process Program Page--Tooling Section.
4.2.4. Separation Program Data
Separation program data determines the distance between the board and the stencil when the
board is at print height. The separation function also determines how the board separates from the
stencil after the print stroke.
Print Gap: Range available from -0.05 inch to 0.2 inch or -1.27 to 6.35mm.
Separation Profile: Enter the specifics required for separation (Figure 47).
Edison Printer User Manual (Part Number 1023838) PROCESS PROGRAM CREATION
Rev. A 73
Copyright © 2017 ITW EAE
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of ITW EAE, unless for purchaser's personal use.
Figure 47. Separation Program Data.
PROCESS PROGRAM CREATION Edison Printer User Manual
74 Rev. A
Copyright © 2017 ITW EAE
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of ITW EAE, unless for purchaser's personal use.
4.2.5. Dispense Program Data
Dispense program data determines how to handle adding paste to the stencil (Figure 48). Use
Dispense Program Data to select the profile of the dispensing material. Selections include:
Material type: Ink, adhesive, solder paste
Auto Dispense: Number of passes, Speed (of passes), Delay (delay start of dispense cycle),
Frequency (print cycles), Left Edge +/- (offset before dispensing), Right Edge +/ - (offset
before dispensing)
Check Prompt user to check paste to set the frequency at which the user should manually
check paste levels. The value displays on the home screen when the printer is in production mode.
The value reduces incrementally (by one) after every print and at zero prompts the user (in the
Alert section) to check the paste.
Figure 48. Dispense Program Data.
4.2.6. Print Head Program Data
Print Head Program Data determines the detailed movement of the print head. Selections include:
Common (Figure 49):
o Positive stroke: Press Calculate Stroke to automatically fill the value. The software
calculates stroke length based on panel size.
o Negative stroke: Press Calculate Stroke to automatically fill the value. The
software calculates stroke length based on panel size.
o Print strokes: Enter number of desired print strokes.
o Print Strokes After Wipe: Enter number of desired print strokes after the wipe.