EdisonStandardOwnersManual-RevA-20170818B - 第79页
Edison Printer User Manual (Part Number 1023838) P ROCESS P ROGRA M C REATION Rev. A 79 Copyright © 2017 ITW EAE All rights reserved. No part of the contents of this manual may be reproduced, copi ed or transmi tted in a…
PROCESS PROGRAM CREATION Edison Printer User Manual
78 Rev. A
Copyright © 2017 ITW EAE
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of ITW EAE, unless for purchaser's personal use.
4.2.7.2. Panel IDs
Panel IDs are fiducials taught to the Intueri software and used to verify the board in the printer is
the correct board to print.
To use Panel IDs, check the Enable Panel ID box (Figure 53).
Each Panel ID taught will be unique to the side of the board being printed. The same feature
should not be on the bottom side of the board or in the same location on a different board.
Figure 53. Vision Program Data.
4.2.7.3. Basic
Click Enable Alignment to allow the Intueri software to automatically align each panel.
Click Enable Panel ID to automatically record each panel ID.
If fiducials had been previously used, Intueri automatically fills in the appropriate X- and Y-
coordinates. Enter desired coordinates as necessary.
If adding fiducials, press + Add to start the Teach Fiducial Wizard
(Figure 53).
4.2.7.4. Teach Fiducial Wizard
The Teach Fiducial Wizard prompts users through the process of panel alignment and
identification.
Edison Printer User Manual (Part Number 1023838) PROCESS PROGRAM CREATION
Rev. A 79
Copyright © 2017 ITW EAE
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of ITW EAE, unless for purchaser's personal use.
Figure 54. The Teach Fiducial Wizard walks through the panel alignment and identification steps.
1. Choose the appropriate setting for how the fiducial will be used (Figure 54) and press Next.
2. On the Panel screen, click Teach New to begin teaching a new fiducial (Figure 57).
3. Load the stencil per screen instructions (Figure 55):
a. Open hood.
b. Load the stencil.
c. Close the hood. The software will display the Load Panel screen (Figure 56).
PROCESS PROGRAM CREATION Edison Printer User Manual
80 Rev. A
Copyright © 2017 ITW EAE
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of ITW EAE, unless for purchaser's personal use.
4. Load the panel into the Edison Printer. The conveyor will move the panel into the worknest
and display the next screen.
5. Click on Teach New to begin teaching the new fiducial to the Intueri software (Figure 57).
Figure 55. Teach Fiducial Wizard: Load Stencil.
Figure 56. Teach Fiducial Wizard: Load Panel.