EdisonStandardOwnersManual-RevA-20170818B - 第92页
P ROCESS P ROGRA M C REATION Edison Printer User Manual 92 Rev. A Copyright © 2017 ITW EAE All rights reserved. No part of the contents of thi s manual may be reproduced, copied or transmitted in any form or by an y mean…
Edison Printer User Manual (Part Number 1023838) PROCESS PROGRAM CREATION
Rev. A 91
Copyright © 2017 ITW EAE
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of ITW EAE, unless for purchaser's personal use.
4.2.9. Print Offsets
Print Offsets are calculated using dimensions from a printed panel (Figure 69). Skip the Print
Offsets section if not using a printed panel. Once taught and saved, a panel can then be printed
and used to adjust print offsets.
Figure 69. Process Program: Print Offsets.
4.2.10. Conveyor
Figure 70 shows the setup screen for the conveyor. Set transport speeds and coordinates for panel
stops as desired.
Figure 70. Process Program: Conveyor
PROCESS PROGRAM CREATION Edison Printer User Manual
92 Rev. A
Copyright © 2017 ITW EAE
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of ITW EAE, unless for purchaser's personal use.
4.2.11. Wiper
Figure 71 shows the wiper configuration screen
Figure 71. Process Program: Wiper Configuration.
Edison Printer User Manual (Part Number 1023838) PROCESS PROGRAM CREATION
Rev. A 93
Copyright © 2017 ITW EAE
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of ITW EAE, unless for purchaser's personal use.
4.3. Create a New Process Program from an Existing Program
Process programs created from an existing program are an exact duplicate of that program.
1. Access the process program page to create a new process program from an existing program
by navigating to File > New >
From Existing (Figure 72).
2. Select the desired process program from list (Figure 73).
a. Save and rename as
desired
b. Include special instructions and comments as necessary (Figure 74).
Figure 72. Create a New from Existing Program.
Figure 73. Pick existing process program to create from.