4OM-1610-002_w - 第80页
4OM-1610 1-29 3. Maintenance Spots : Chap.1 091 1-001 Removed fluorine-processed sheet. Front Safety Bar (2) Remove the tape guide. (1) Remove the front safety bar and take out the cutter from the cart. (3) Remove five s…
4OM-1610
1-28
3. Maintenance Spots : Chap.1
1011-002
WARNING
Pay close attention to the cutter blade during the
maintenance work.
•
Lack of attention will result in a hand injury, etc.
Wear gloves and take the greatest care in
performing the work.
•
Be sure to attach the cutter blade cover to the
cut unit during the maintenance work for safety
purposes.
Attachment Position of Cut Unit Fixing Jig
(1) Remove 11 screws and detach the cover.
(2) Use the cutter unit fixing jig with the tape clamp closed to fix the urethane clamp section.
Replacement Jig Attached
(3) Remove the bolts (6 locations)
on the shield cover.
(4) Change the flat ring.
(5) Put the shield cover and attach the bolts (6 locations) on it.
(Tightening Torque: 18.6 to 22.6Ncm (1.9 to 23 kgkm))
Bolt
Bolt
Flat Ring
Every Year Replacement Required Time: 10 minutes
F4A22
CAUTION
Whentheatringiscut,takecarenottogetinjured
by the commercially available cutter.
4OM-1610
1-29
3. Maintenance Spots : Chap.1
0911-001
Removed fluorine-processed sheet.
Front Safety Bar
(2) Remove the tape guide.
(1) Remove the front safety bar and take out the cutter
from the cart.
(3) Remove five screws.
(4) Replace the fluorine sheet.
Fluorine Sheet
Every Year Replacement Required Time: 15 minutes
Catch Lock
(a) When the cutter is to be placed on the cart,
fix the two sections on the connector securely.
(b) When the cutter is to be placed on the cart,
insert the cutter to the end and fix it with the catch lock (two locations) securely.
(c) Make sure to attach the safety cover.
Note
F4A23
4OM-1610
1-30
3. Maintenance Spots : Chap.1
Note
(3) Attach the cutter blade cover.
(1) Remove the front safety bar and take out the
cutter from the cart.
② ⑥①
④ ⑤③
③
②
⑥
⑤
When the cutter is mounted on the cart, fix the connector (two locations) securely.
Also, do not forget to attach the safety cover.
Front
Safety Bar
Urethane Clamp
(2) Remove the cutter section covers (6 locations).
(4) Remove the screws on the right and left of the clamp
lever base.
(5) Remove the clamp lever together with the clamp
lever base.
(6) Remove the clamp lever from the clamp lever base
and replace the clamp lever by new one.
Remove
the screw.
Remove the screw also on the other side.
Every Year Replacement Required Time: 30 minutes
F4A24
0911-001