Covers.pdf - 第12页

COVERS MACHINE COVERS 3.12 Technical Reference Manu al Chapter Issue 2 Sep 09 Upper Side Panels T o remove an upper side p anel, carry out the following: 1. Lift the slidin g glass cover . 2. Lift the rear printhea d cov…

COVERS

MACHINE COVERS

Chapter Issue 2 Sep 09 Technical Reference Manual 3.11

3. Tilt the top of the panel away from the machine and lift the panel clear of the

location pins at the bottom.

Rear Panel To remove the rear panel, carry out the following:

1. Lift the rear printhead cover.

2. Release the two quarter-turn ring fasteners located externally at the top

corners of the panel.

3. Tilt the top of the panel away from the machine and lift the panel clear of the

location pins at the bottom.

Safety Covers Safety covers are fitted to the side panels to protect personnel from inadvertent

access to the product entry/exit ports.

To remove the safety covers, remove the four securing screws, stand-offs and

washers; remove the cover.

Standard Safety Covers

HTC Safety Covers

(showing the two halves)

COVERS

MACHINE COVERS

3.12 Technical Reference Manual Chapter Issue 2 Sep 09

Upper Side Panels To remove an upper side panel, carry out the following:

1. Lift the sliding glass cover.

2. Lift the rear printhead cover.

3. Remove the safety cover.

4. At the front of the upper side panel, remove the appropriate upper panel

switch contact blocks (System, Jog or Internal light.) The blocks are located

at the rear of the switch bezel.

5. The contact block can be separated from the bezel, (hold the body part to

remove the contact blocks, not the switch wires) by pulling it out of the bezel.

Switches (System, Jog)

COVERS

MACHINE COVERS

Chapter Issue 2 Sep 09 Technical Reference Manual 3.13

When refitting, the contact body is aligned with the bezel.

6. Release the quarter-turn ring latch fastener, located internally at the top front

of the cover.

7. Release the front and rear quarter-turn ring latches located above the front

Switch Contact Block Removed