4OM-1003-007 - 第105页
(23) Nozzle Guide Section 1.3 Maintenance Spots 051 1-003 1-42 AIL01ETRP Fig. 4A47 Nozzle Guide Cam Upper and Lower Surfaces 1M39 Every Month Lubrication (MOL YNOC GREASE AP1) Replenish grease every month or after the ma…
(22) Tape Feed Unit Section
1.3 Maintenance Spots
0511-002 1-41 AIL01ETRP
Lever End of Tape Feed Stopper and 1M38
Cam Follower Outer Ring Stopper Block
Every Month Lubrication (MOLYNOC GREASE AP1)
Apply grease to the contacting surface of the cam follower with
a dispense gun.
* Use No. 19 (brown) nozzle.
Rod Ends 6M7
Every 6 Months Lubrication
(DAPHNE EPONEX GREASE No. 1)
Inject new grease from the grease nipple with
a grease gun.
* Use U- and L-type or U- and V-type
attachments.
U Type L Type V Type
Ball Splines 3M24
Every 3 Months Lubrication
(DAPHNE EPONEX GREASE No. 1)
Inject new grease from the grease nipple
with a grease gun.
* Use SPK-3C attachment.
Grease should be applied every 3 months
after the initial month.
Springs 3M25
Every 3 Months Lubrication
(DAPHNE EPONEX GREASE No. 1)
Wipe off the old grease on each spring with
a rag and apply new one by hand or using a
brush.
Grease should be applied every 3 months after
the initial month.
Fig. 4A46
(23) Nozzle Guide Section
1.3 Maintenance Spots
0511-003 1-42 AIL01ETRP
Fig. 4A47
Nozzle Guide Cam Upper and Lower Surfaces 1M39
Every Month Lubrication (MOLYNOC GREASE AP1)
Replenish grease every month or after the machine has been stopped for
a long period of time (more than a week).
Apply grease evenly to the upper and lower surfaces of the nozzle guide
cam by hand or using a brush and perform an aging operation.
Refer to "4.5 "Aging" Tab" in "Section 6" of the instruction manual (Vol. 2:
Operation (Supervisor)) for the aging operation.
Note: Wipe off the dispersed grease.
(24) Head Up/Down Section
1.3 Maintenance Spots
0511-002 1-43 AIL01ETRP
Oil Inlets
Every 3 Months Lubrication (DAPHNE EPONEX GREASE No. 1)
Apply grease with a dispense gun.
* Use No. 14 (olive) nozzle.
Cam Follower of Top Block 3M26
Upper Section of Linear Guide 3M27
Every 3 Months Lubrication (DAPHNE EPONEX GREASE No. 3)
Follow the steps below for the lubrication.
1. Close the air valve and allow the air to bleed out of the machine.
2. Rotate the rotary turret with the hand-rotating wheel to move the linear
guide to be lubricated between Stations #3 and #4
(Turret Angle: 108 degrees).
3. Set the dispense gun to "1".
4. Insert the nozzle to be used into the oil inlet and inject grease slowly,
spending about 10 seconds.
Note: Inject grease (quantity: 0.06 to 0.1 g) only once.
* Use the HL2-type nozzle.
Grease should be applied every 3 months after the initial month.
Fig. 4A48