4OM-1003-007 - 第152页

0305-001 1-86 AIL01ETRP 1.4 Maintenance Method • • • • • Reference Mark Detection (1) When the "Ref Mark Detect" tab is pressed in the "Fdr Crg" tab sheet, the following tab sheet appears. Fig. 4A91-1…

0305-001 1-85 AIL01ETRP

1.4 Maintenance Method

(5) Pass the head cleaning paper through the clearance and slide it

right and left 10 to 20 times, keeping the effective length of the

stoke.

Fig. 4A89

(6) Pull out the head cleaning paper such that the folded part (folding

mark) should pass through the clearance between the encoder head

and the scale holder as shown below.

Fig. 4A90

(7) Follow Steps (2) through (6) again, using new head cleaning paper.

(8) After the cleaning, move the feeder carriage sideways and clean

the linear scale with a cotton swab soaked in alcohol (absolute etha-

nol).

(9) Power up the machine and perform "Reference Mark Detection

Mode" to check the feeder carriage movement.

0305-001 1-86 AIL01ETRP

1.4 Maintenance Method

••

• Reference Mark Detection

(1) When the "Ref Mark Detect" tab is pressed in the "Fdr Crg" tab

sheet, the following tab sheet appears.

Fig. 4A91-1 "Ref Mark Detect" Tab Sheet

(2) When the [Start Reference Mark Detection] button is pressed in the

"Ref Mark Detect" tab sheet, the following sheet appears.

Fig. 4A91-2

0305-001 1-87 AIL01ETRP

1.4 Maintenance Method

(3) Press the [ON] button entitled "MOVE". In 2 seconds, press the

[ENABLE] button on the operation panel.

The feeder carriage moves to the F1 side and the following sheet

appears.

Fig. 4A91-3

(4) Press the [Next] button.

(5) Repeat the same steps and confirm that the reference mark can be

detected.