SM411F_Service Manual - 第40页
X7043 STEP CONTROL Board [5-7] CONTROL RACK (New) ◆ Picture of X7043 STEP control board ◆ Board for step d river only ( 8 axis) - PB AMP 3 axis control - Work axis 4 axis control ◆ Optimization of connector and cable b…
X7043 SEDES Board(1)
[5-5] CONTROL RACK (New)
◆ Picture of X7043 SEDES board
◆ Control of all axis corresponding to 1
gantry (Excepting Y)
- Control of X, Mirror axis pulse in/out
- Control of Z1~Z6 Se-Des in/out
- Control of axis sensor (X, Mirror ,Z and
Theta) Des
- Pulse out (Theta1~3) for Step only
◆ Use of main clock of 20MHz
- Obtaining cable distance of 10M in the
specification
- Control of Se-Des in/out by using high
speed communication of 140MHz
◆ Design of 12 axis control board resulted
from epochal reduction of the number of
cable
37
X7043 SEDES Slave Board
[5-6] CONTROL RACK (New)
◆ Conversion of SEDES in/out signal
into pulse type in/out signal and I/O of
general contact point
◆ Function of each part
1. Z1, Z2 Servo AMP IF Part
2. Z3, Z4 Servo AMP IF Part
3. Z5, Z6 Servo AMP IF Part
4. SE-DES In/Out IF Part
( to X7043 SEDES Board)
5. X, Mirror , Z1, Z2 Axis Sensor
6. Z3, Z4, Z5, Z6 Axis Sensor
7. Theta1, Theta2, Theta3 Axis Sensor
38
X7043 STEP CONTROL Board
[5-7] CONTROL RACK (New)
◆ Picture of X7043 STEP control board
◆ Board for step driver only ( 8 axis)
- PB AMP 3 axis control
- Work axis 4 axis control
◆ Optimization of connector and cable by
designing for step driver only
◆ Improvement of design to optimize the
cost
39
SM411(F) VME IO ILL Board
[5-8] CONTROL RACK (New)
◆ Picture of SM411 VME IO ILL board
◆ Control of vacuum on and off for gantry 1 and 2
◆ illumination control (front/rear) for stage
camera
- Outer illumination: Control in 256 stages
- Inner illumination: Control in 256 stages
◆ Control of conveyor related IO
- Control of sensor input 12ch (Interrupted)
- Control of output 16ch
40
SM411(F) CAN MASTER Board
[5-9] CONTROL RACK (New)
◆ Picture of SM411 CAN master board
◆ Increase of CAN communication channel (2ch)
◆ Common use of CAN cable
- Existing machine is a
pp
lied without changing
cables applied by SM320 CAN cable and SM321
CAN cable.
41
Other I/O board assembly
1) Head ILL board X 2 EA (Common use for SM321)
2) Head IO board X 2 EA (Common use for SM321)
3) Front & rear feeder control board X 1 set (Common use for SM321)
Æ Front feeder base (60EA) and rear feeder base (60EA) feeder control
4) Conveyor I/F board X 1 EA (Common use for SM321)
[5-10] Other I/O B/D
42