2OM-1075-002.pdf - 第223页

AHB01ESPP 7 . 4 "Feeder Unit Set Status" T ab The corresponding tab sheet enables the operator to confirm the re- quired feeders and check if the correct feeders are actually installed on the feeder bases. • • …

AHB01ESPP

*2 Mode

Displayed is the operating mode of each device.

*3 "Control Sw" Group Box

When the [ENABLE] button on the operation panel is pressed in 2

seconds after one of the buttons in "*1" is selected and the [ON]

button (entitled "MOVE") is pressed, the action corresponding to the

selected button takes place.

••

• Operation Procedure

(1) Select one of the buttons in "*1" as the device to be inspected.

(2) Press the [ON] button (entitled "MOVE"). In 2 seconds, press the

[ENABLE] button on the operation panel. The motor starts rotating.

To stop the rotation, press the [STOP] button on the operation panel.

7.3 "PCB Support Pins Set-up Mode" Tab

0206-001 5-56-2

AHB01ESPP

7.4 "Feeder Unit Set Status" Tab

The corresponding tab sheet enables the operator to confirm the re-

quired feeders and check if the correct feeders are actually installed on

the feeder bases.

••

• Sheet Layout

When the "Feeder Unit Set Status" tab is pressed in the "PRGM. CHG."

window (submenu), the following tab sheet appears.

Fig. 2E48 "Feeder Unit Set Status" Tab Sheet

The tab sheet may look different, depending on which options

are selected.

••

• Sheet Composition

*1 Crnt. Prgm.

Displayed are the types of the feeders specified in the placement

feeder location data.

*2 Status

Displayed are the types of the actually installed feeders.

7.4 "Feeder Unit Set Status" Tab

Note

0206-002 5-57

AHB01ESPP

8. Running-In Operation

After the machine has been stopped for a long period of time, perform a

running-in operation for approx. 30 minutes to smoothly start up the

machine.

Operation Procedure

(1) Select the required pattern program and perform the program and

product change operations.

Refer to "7. "PRGM. CHG." Window (Submenu)" in "Section 5"

for the program and product change operations.

Observe the following to prevent any deficiency

in the running-in operation.

• Do not set any P.C.B. to be produced on the ma-

chine.

• The feeders can be installed on the feeder bases.

However, it should be noted that the settings of the

test run (described hereinafter) must be correctly

made.

8. Running-In Operation

Note

0308-002 5-58

CAUTION