2OM-1075-002.pdf - 第349页

AHB01ESPP 5.2.4 "Comp Library" T ab • • • • • Sheet Layout When the "Comp Library" tab is pressed in the "TEACHING" window (submenu), the following tab sheet appears. (Operation Sequence: [M…

AHB01ESPP

5.2.3 Component Library Teaching Procedure

Shown below is the component library data teaching sequence.

The numbers in ( ) show the item Nos. to be referred to.

Fig. 2F82

5.2 Library Teaching

Note

0308-004 6-116

AHB01ESPP

5.2.4 "Comp Library" Tab

••

• Sheet Layout

When the "Comp Library" tab is pressed in the "TEACHING" window

(submenu), the following tab sheet appears. (Operation Sequence:

[MAINT.] Button Æ [TEACHING] Button on Submenu Bar Æ "Comp Li-

brary" Tab)

The following tab sheet cannot be opened when the machine is

in the "RUN"or the "PAUSE" mode, or the preparations for rec-

ognition are not completed.

Fig. 2F83 "Comp Library" Tab Sheet

••

• Sheet Composition

*1 "Teach Mode" Group Box

[New Creation] Button

When pressed, this button makes it possible to create new compo-

nent library data.

When the [New Creation] button is pressed, "Set Initial Data (New)"

sheet appears.

[Modify] Button

When pressed, this button makes it possible to modify the test li-

brary data.

When the [Modify] button is pressed, the "Test ID Set" sheet ap-

pears.

5.2 Library Teaching

Note

0206-003 6-117

AHB01ESPP

5.2.4.1 "Set Initial Data (New)" Sheet

••

• Sheet Layout

When the [New Creation] button is pressed in the "Comp Library" tab

sheet, the following sheet appears.

Fig. 2F84

Operation Procedure

(1) Press the [Component ID] button.

The "Component ID" window opens.

(2) Enter a component ID and press the [Set] button.

Also, enter a comment if necessary.

(3) Set the initial parameters and press the [Rtn] button.

When a component is attached by hand, it is not necessary

to enter any parameters in the "Tape width [mm]", "Tape

feed pitch [mm]", "Pickup level [mm]", and "Placement level

[mm]" text boxes and any speed data for "Selected nozzle

#1" and "Selected nozzle #2" in the "Component Library"

window.

These parameters can be edited after a teaching operation

is completed.

(4) Press the [Set] button after the initial parameter settings are com-

pleted and verified.

The "Teach Library (New)" sheet appears. Refer to "5.2.5 "Teach

Library (New)" Sheet" for details.

5.2 Library Teaching

Note

0206-003 6-118

[Set] Button