00198045-01_OM_BulkFeeder_X_EN - 第7页
SIPLACE BulkFeede r X / Operating Ma nual 05/2017 Edition 7 1.2 Operational S afety 1.2.1 Warning Labels High temperatures aroun d the camera CAUTION Hot s urface warning The camera may be hot . Be careful when touc hing…
SIPLACE BulkFeeder X / Operating Manual 05/2017 Edition
6
1.1.1 Conventions for the Use of Safety Instructions
This manual contains notes that must be observed to guarantee your personal safety and to avoid
damage to equipment. These notes are highlighted by warning triangles and are indicated as
follows according to the level of risk:
DANGER
Definition
For the purposes of this manual, this indicates that fatal or severe injuries or
considerable damage to property will occur if this hazard warning is not observed.
WARNING
Definition
For the purposes of this manual, this indicates that fatal or severe injuries or
considerable damage to equipment may occur if these warning instructions are not
followed.
CAUTION
Definition
For the purposes of this manual, this indicates that minor injuries or damage to property
may occur if this caution is not observed.
NOTICE
Definition
For the purposes of this manual, this note provides information about the product or
indicates a part of the manual that requires particular attention.
SIPLACE BulkFeeder X / Operating Manual 05/2017 Edition
7
1.2 Operational Safety
1.2.1 Warning Labels
High temperatures around the camera
CAUTION
Hot surface warning
The camera may be hot. Be careful when touching the BulkFeeder X.
1.2.2 Feeder Handling
Base Unit
Carry the Base Unit in the handle (1). ►
NOTICE
Only move the Base Unit with installed Cartridge.
As the weight is nearly 6.5 kg, it may be necessary to carry the Base Unit with both
hands.
Pick the Base Unit in the handle with one hand and at the front side (close to the EDIF and ►
front centering pin) with the other hand.
Do not touch the gap on the side panels where the camera is installed. The camera might get ►
out of place.
Treat the Base Unit carefully. ►
The Base Unit is equipped with a small foot on the side of the 3rd track. Thus, it can be put down
standing on the table. However, due to the small support base it is safer to lay it down on the side
on a smooth surface.
Do NOT throw, drop or overbalance the Base Unit.
SIPLACE BulkFeeder X / Operating Manual 05/2017 Edition
8
Cartridge
Carry the Cartridge by picking it in the middle. ►
Do not touch the plate with the plate shutter and pickup plate (1). This mechanism is very ►
damageable.
The Cartridge can be put down on the table.
1.2.3 Classification of the SIPLACE BulkFeeder X Illumination
NOTICE
Bright LEDs are installed in the SIPLACE BulkFeeder X. These are classified in the risk
group 1 in accordance with IEC 62471:2006.
Do not look into the beam! ►