1OM-1625-004_w.pdf - 第140页
1OM-1603 3-17 2. Program Change Operation : Chap.3 1012-001 (6) Connect the connector of the cart to the connector on the machine side and set the connector xing lever in place. Notice When the bank feeder change cart m…
1OM-1603
3-16
2. Program Change Operation : Chap.3
1012-001
2.2.5 Replacement of Bank Feeder Change Cart
CAUTION
Do not put your hand in the moving area while the
feeder base is moving up or down.
While the LED of the Feeder Ready switches are being
ickering, it indicates that the corresponding feeder base
is moving up and down.
Procedure
(1) Press the Feeder Ready switches of the machine.
(The feeder READY switch LED will be extinguishes and the feeder base is
unclamped.)
(2) Keep pressing the Feeder Ready switches of the machine a little longer.
(The feeder base starts moving down and the LED of the Feeder Ready
switches starts ickering, indicating that the feeder base is being activated.)
When the disconnection operation of the bank feeder change cart is
completed, the LED of the Feeder Ready switches extinguishes.
(3) Detach the connector xing lever and pull out the connector for the bank
feeder change cart from the connector to the machine. Then, catch the
connector on the magic tape section on the side of the cart.
Notice
(a) Do not use the connector catching section for any purpose
otherthanforcatchingthespeciedsectionoftheconnector.
Also, do not put any excessive force on it. Doing so might
damage the connector.
(b) During the machine operation, do not disconnect the connector.
For the feeder base connector, connect or disconnect it when
the feeder base is lowered to the end and it has stopped.
(4) Release the two stopper brakes of the bank feeder change cart and draw out
the cart from the machine.
(5) Insert the bank feeder change cart (provided with the tape feeders set ready
for use) into the machine and lock the two stopper brakes.
Notice
(a) When the bank feeder change cart must be pushed into the
machine, push it straight such that the guide on the machine
side can be located inside the cart arm.
Also, insert it taking care that your hand holding the cart handle
does not hit the cover.
(b) When the cart is not positioned correctly, the connection
operation cannot be performed.
Besuretopushthecart
rmlyuntilittouchesthestopper.
1OM-1603
3-17
2. Program Change Operation : Chap.3
1012-001
(6) Connect the connector of the cart to the connector on the machine side and
set the connector xing lever in place.
Notice
When the bank feeder change cart must be pushed into the
machine, push it straight such that the guide on the machine side
can be located inside the cart arm.
(7) Press the Feeder Ready switches of the machine.
(The feeder base starts moving up and the LED of the Feeder Ready switches
starts ickering, indicating that the feeder base is being activated.)
(8) Press the Feeder Ready switches of the machine.
The feeder READY switch LED is turned ON and the feeder base is
clamped.
1OM-1603
3-18
2. Program Change Operation : Chap.3
1012-005
2.3 Program Change Operation
2.3.1 Selection of Run Mode
Set the "Run Mode" on the "Run Mode" tab sheet in the "OPERATION" window.
F1C14
Procedure
(1) Press the [Run Mode] tab on the "OPERATION" window.
(2) Press the [Place] button on the "Run Mode" tab sheet.
Graphic
Development