YS100_Ope_E - 第115页
2-48 2 asic operation 4 Replace the pallets (when replacing pallets only). Proceed to step 5 when replacing the magazine. 1. Open the pallet retainer door . Open the pallet retainer door while depr essing the latch lev…
2-47
2
asic operation
4.3.3 Replacing a magazine or pallets during operation (dYTF)
The dYTF allows you to replace a magazine or pallets even when the mounter is operating. You can make setup
for tray components without decreasing the rate of production. (Magazine being used during operation cannot
be replaced.)
This section explains how to replace a magazine or pallets.
1
Set the door switch for the magazine you want to replace to "OPEN".
The magazine door unlocks and the door switch lamp turns off.
Door switch
Door switch
23223-L1-00
2
Open the magazine door.
Pull down the handle to open the magazine door for the magazine you want to replace.
3
Unclamp the magazine.
Turn the clamp lever to the left while pulling it.
Magazine clamp
Turn the clamp lever to the left to unclamp the magazine.
23225-L1-10
2-48
2
asic operation
4
Replace the pallets (when replacing pallets only).
Proceed to step 5 when replacing the magazine.
1. Open the pallet retainer door.
Open the pallet retainer door while depressing the latch levers.
2. Replace the pallets.
3. Return the pallet retainer door to the original position.
Replace the pallets
Latch levers
Pallet retainer door
23238-L1-00
5
Pull out the entire magazine.
Holding the handle on the pallet retainer door, slowly pull the magazine straight out.
Pulling out the magazine
Guide
23226-L1-10
2-49
2
asic operation
6
Insert the new magazine.
Align the grooves in the bottom of the magazine with the guides on the inner side of the magazine door,
and slowly insert in until the magazine stops.
7
Clamp the magazine.
While pulling the clamp lever, turn it to the right to clamp the magazine.
8
Press the indicator buttons.
Press the indicator buttons for the pallets that have been newly set.
9
Close the magazine door.
0
Return the door switch to "CLOSE".
The magazine door is closed and the door switch lamp lights up.
c
Automatic operation stops due to an error if an instruction to replace the currently used pallet is issued while you are
exchanging a magazine or pallets.