YS100_Ope_E - 第67页
Chapter 2 Basic operation Contents 1 1.1 Canceling emergency stop 2- 1 1.2 Clearing an error 2- 2 1.3 Typical err ors and troubleshooting 2- 3 0 …
1-31
1
Part names and functions
9.3 Coplanarity checker
The coplanarity checker measures lead linearity and coplanarity of QFP/SOP leads or BGA bumps at high
speeds, and determines "pass/fail".
The coplanarity checker has the following two functions:
• Coplanarity check
Inspects uniformity of the lead bottom against the seating plane of components having wire leads or solder balls.
• Component recognition height check
Prevents lead components from being mounted in an inverted position.
Coplanarity checker
Multi-vision camera (standard)
Coplanarity checker
Single-vision camera
23128-L1-00
n
NOTE
For instructions on how to use the coplanarity checker, refer to the YS series programming manual.
Chapter 2 Basic operation
Contents
1
1.1 Canceling emergency stop 2-1
1.2 Clearing an error 2-2
1.3 Typical errors and troubleshooting 2-3
0
0
2.2 Setup screen 2-13
2.3 Unit screen 2-14
3. Starting and stopping the machine 2-19
3.1 Pre-operation check 2-20
3.2 Starting the machine 2-21
3.3 Warming up the machine 2-23
5
3.4.1 Conveyor unit setup flow 2-25
3.4.2 Conveyor width 2-26
3.4.3 Board hold plates 2-27
3.4.4 Push-up pins 2-28
4. Preparing the component supply unit 2-29
4.1 Tape feeder 2-29
4.1.1 Setting the tape 2-29
4.1.2 Setting a tape feed pitch 2-34
4.1.3 Installation on a mounter 2-38
4.2 Wide multi-stick feeder 2-39
4.2.1 Installation of tracks and sticks 2-39
4.2.2 Installation on a mounter 2-42
4.3 Tray changer 2-43
4.3.1 Setting the component trays in the pallet 2-44
4.3.2 Setting the pallet in the magazine 2-45
4.3.3 Replacing a magazine or pallets during operation (dYTF) 2-47
5. Settings on the mounter side 2-50
5.1 Setting the "Package" parameter. 2-50
5
2-1
2
asic operation
1. Before operation
The following explains how to cancel emergency stop and clear errors. Read before operating the machine.
n
Cautions during machine operation
• Do not turn off the compressed air during operation. The machine may malfunction, as pneumatic devices are not
correctly controlled.
• Before beginning maintenance work, always make sure that no air pressure remains in air cylinders.
n
Cautions during power outages
If a power outage (blackout) occurs during automatic machine operation, always turn the main power switch off to
prevent faulty operation or machine damage after power has been restored.
1.1 Canceling emergency stop
Follow these steps to cancel emergency stop.
1
Release the emergency stop button.
When the emergency stop button is pressed, turn it clockwise to release it.
2
Check safety.
Before continuing the procedure, check the surrounding area for safety.
3
Press the [READY] button.
Pressing the [READY] button on the operation panel turns on the servomotors.
c
[READY] button
Press the [READY] button to turn on the servo.
23200-L1-00
4
Check the signal light and screen display.
Check that the red lamp of the signal light is off and the emergency stop sign on the top left (status
area) of the operation screen is now off.