00194474-0702_AI_HeadReconfig_X_605_DE EN - 第186页
2 Assembly Instructions - SIPLACE X-Series Head Reconfiguration Kits Head Reconfiguration Kits 07/2010 Edition 186 : Plug the camera cable into the he ad interface board (see photograph). : Plug the four ribbo n cables i…
Head Reconfiguration Kits 2 Assembly Instructions - SIPLACE X-Series Head Reconfiguration Kits
07/2010 Edition
185
: Fit the component camera for the DLM head ( 4 screws DIN912 M4x10 - A2, item no.
00313069-).
: Plug in the connectors for the DP axis.
2
: Plug in the two connectors.
2
: Clip on the strain relief pushbutton.
2 Assembly Instructions - SIPLACE X-Series Head Reconfiguration Kits Head Reconfiguration Kits
07/2010 Edition
186
: Plug the camera cable into the head interface board (see photograph).
: Plug the four ribbon cables into the step motor board. Make sure that the polarization is correct.
2
: Check the jumper settings on the C500 head interface board.
Jumper
Gantry
1
Gantry
2
Gantry
3
Gantry
4
1
0 1 0 1 Gantry ID0
2
0 0 1 1 Gantry ID1
3
1 1 1 1 120 Ohm CAN terminating resistor
4
0 0 0 0 Boot
5
0 0 0 0 Reset
6
0 0 0 0 CAN ID0
7
0 0 0 0 CAN ID1
8
0 0 0 0 Write protect deactivated
Component camera cable
Head Reconfiguration Kits 2 Assembly Instructions - SIPLACE X-Series Head Reconfiguration Kits
07/2010 Edition
187
: If problems occur with the CAN bus, measure the resistance between pin 7 (CAN High) and
pin 2 (CAN Low). It should be 60 Ohm.
2
: Fit the cap (type D Di8.0 H15 flexible PVC, item no. 03006728-) on the exhaust air damper.
Jumper
position