00194474-0702_AI_HeadReconfig_X_605_DE EN - 第219页

Head Reconfiguration Kits 2 Assemb ly Instructions - SIPLACE X-Series Head Reconfiguration Kits 07/2010 Edition 219 : If problems occur with the CAN bus, measu re the resist ance between pin 7 (CAN High) and pin 2 (CAN L…

100%1 / 276
2 Assembly Instructions - SIPLACE X-Series Head Reconfiguration Kits Head Reconfiguration Kits
07/2010 Edition
218
: Start by fitting the inner TwinHead module (module 1) with four screws (because these screws
are more easily accessible).
Make sure that the screws are the right length and that you are using the correct torque:
DIN912 M4x14 - 8.8(item no.: 00095021-), tightening torque: 2.7 Nm.
2
2
: Before attaching the outer module (module 2) to the head, insert the screws into the holes be-
tween the modules.
: Screws on the outer module , turned through 180° around the D axis.
2
: Check the jumper settings on the C500 head interface board.
2
Jumper
Gantry
1
Gantry
2
Gantry
3
Gantry
4
1
0 1 0 1 Gantry ID0
2
0 0 1 1 Gantry ID1
3
0 0 0 0 120 Ohm CAN terminating resistor
4
0 0 0 0 Boot
5
0 0 0 0 Reset
6
0 0 0 0 CAN ID0
7
0 0 0 0 CAN ID1
8
0 0 0 0 Write protect deactivated
Head Reconfiguration Kits 2 Assembly Instructions - SIPLACE X-Series Head Reconfiguration Kits
07/2010 Edition
219
: If problems occur with the CAN bus, measure the resistance between pin 7 (CAN High) and
pin 2 (CAN Low). It should be 60 Ohm.
2
2.12.8 Connections on the compressed air distributor
There are currently two different pneumatic distributors available depending on the cable and
hose carrier installed:
– Use the old cable and hose carrier on CFK gantries 02 and 04 for the old pneumatic distributor
and
– the new pneumatic distributor for the "CFK 06 gantry, new cable and hose carrier". These new
distributors are prepared for the vacuum pump on the C&P 20 head option.
Jumper
position
2 Assembly Instructions - SIPLACE X-Series Head Reconfiguration Kits Head Reconfiguration Kits
07/2010 Edition
220
2
2
Plug QSC-6H Item no. 00337891-
Plug QSC-4H Item no. 00330249-
Plug QSC-8H Item no. 03010908-
Plug QSC-10H Item no. 00324874-
Plug QSC-12H Item no. 03015210-
Gantries CFK 02 and CFK 04
Gantry CFK 06
Pneumatic distributor back
Input:
7x pneumatic hose (PK6)
2x pneumatic hose
vacuum pump option (PK10)
Pneumatic distributor front
Output:
TwinHead
Pneumatic distributor back
Input:
7x pneumatic hose
Pneumatic distributor front
Output:
TwinHead
Pressure
control valve
segment 1
Return cylinder
Pressure
control valve
segment 2
Pressure
control valve
segment 1
Return cylinder, segments 1
and 2
Pressure
control valve
segment 2