00195166-0402_SM_D4_EN - 第216页

Settings Gantry Description of the PCB boards on the Gantry 216 Serv ice Manual SIPLACE D4 6.2.3 Description of the PCB boards on the Gantry The boards on the gantry de scribed below are ba sically identical and do not d…

Settings

Anticrash Function for the A364 Axis Card Gantry

Service Manual SIPLACE D4

215

6.2.2.5 Anticrash Function - Procedure

6-3: Example of the sequence for the anticrash function in placement area 1

Settings

Gantry Description of the PCB boards on the Gantry

216 Service Manual SIPLACE D4

6.2.3 Description of the PCB boards on the Gantry

The boards on the gantry described below are basically identical and do not depend on the head

configuration of D1, D2 and D4 machines (the D3 has a different board here). The CAN bus terminating

resistor is fixed onto the gantry head distributor.

6.2.3.1 Gantry Head Distributor

6-4: Gantry head distributor (from above)

Legend

1 X20 stepping motor for reject position

X19 stepping motor for pickup/place

X18 stepping motor for swiveling in the DP axis

6 X24 Test connector for „digital track signals for

X-axis“

7 X29 connector for Vision board

2 X13/X14 flat ribbon cable to C&P head 8 X10 Connector vacuum measurement board

X12 DP axis motor

X16 Reference proximity switch (nor used)

X17 X-axis end position proximity switch (not

used)

X22 Temperature feeler

X21 Free (not used)

3 X11 test connector for CAN Bus, SPI Bus,

RS232

4 X30/X31 flat ribbon cable to P&P head for D1

(D4 not in use)

5 X5/X6 connector for 16 bit processor (TQM) 9 X26 connector for CO sensor

Settings

Description of the PCB boards on the Gantry Gantry

Service Manual SIPLACE D4

217

6-5: Gantry head distributor (from below)

Legend