00195166-0402_SM_D4_EN - 第38页
Overview Component Handling Cutter 38 Serv ice Manual SIPLACE D4 3.4.2.2 Overview: Mechanical Construct ion 3-21: Overview: of Pneumatic Cutter Version 04 and Empty-Tape Duct Version 03 Legend *) Loosen these screws only…
Overview
Cutter Component Handling
Service Manual SIPLACE D4
37
3.4.2 Cutter
3.4.2.1 Safety Instructions
DANGER:
The safety instructions in the chapter "Operational Safety" in the operating manual and this
service manual take priority.
The machine is supplied with
219/380 V +/- 5% or
230/400 V +/- 5% or
239/415 V +/- 5% or
117/204 V +/- 5% or
133/230 V +/- 5%,
50/60 Hz mains voltage.
Inside the machine base this is true even while the master switch is turned off.
X The machine has to be switched OFF and disconnected from the line before you perform any
work in the area of the cutter.
X In addition, the compressed air supply must be turned off at the main valve of the compressed
air unit in the machine base and the compressed air lines must be bled by actuating the
needle valve on the compressed air unit.
X Always secure the machine against unauthorized reactivation, as described in the User
Manual, chapter "Lock-Out and Tag-Out Procedure ...".
WARNING:
X Wear appropriately thick protective gloves when working near the blades/the tape deflector!
X There is a high risk of injury from stationary blades and moveable blades and from the tape
deflector of the cutter, even when the machine has been turned off!
X Never reach into the pneumatic cutter from below or into the empty-tape duct from above, not
even to resolve a problem (e.g. when tape is jammed).
Overview
Component Handling Cutter
38 Service Manual SIPLACE D4
3.4.2.2 Overview: Mechanical Construction
3-21: Overview: of Pneumatic Cutter Version 04 and Empty-Tape Duct Version 03
Legend
*) Loosen these screws only when removing/installing the cutter.
See also:
J
4.3.2.5 Exchanging the Pneumatic Cutter [
J
87]
1 "Pneumatic cutter" 9 Fastening of "empty-tape duct assembly":
2 socket hex head cap screws M 4 x 16 each on
left and right
2 Retaining bracket for cutter, left
3 Retaining bracket for cutter, right
4 Fastening of the cutter,
2 socket hex head cap screws M6 x 25 each on
left and right *)
Re-install any disks or plates that were
previously removed.
10 Mounting surface for the "empty-tape duct
assembly" on the machine base
11 Baffle, inside
12 Baffle, outside
5 Mounting surface for cutter on the machine base 13 Reject box for nozzles
14 Reject box (profile)
6 Empty-tape duct assembly 15 Stop buffer assembly on left and right-hand side
of the machine base,
Fastening: 2 socket hex head cap screws M8
each on left and right
7 Side panel (left) of the empty-tape duct
8 Side panel (right) of the empty-tape duct
Overview
Cutter Component Handling
Service Manual SIPLACE D4
39
3.4.2.3 Diagrams of Pneumatic System and Functional Sequence
3-22: Diagram of Pneumatic System: Cutter per conveyor edge