00198576-01_JG_Nozzles_E-by-SIPLACE_EN - 第12页
1 - 8 www.e-by-siplace.com Rule 4: If the component has a special feature, such as a wider lead, this special feature will be at the bottom. Rule 1 has top priority, followed by rules 2, 3 and 4.
1 - 7
www.e-by-siplace.com
Rule 2: Pin 1 is in the bottom, left corner or at the center of the component's left side. In the case of diodes, the an-
ode (+) must point in the positive X direction.
Rule 3: The side with the most leads is at the bottom.
1 - 8
www.e-by-siplace.com
Rule 4: If the component has a special feature, such as a wider lead, this special feature will be at the bottom.
Rule 1 has top priority, followed by rules 2, 3 and 4.
1 - 9
www.e-by-siplace.com
Correct Assignment of Nozzle – Component for SIPLACE
To prevent any detection problems with small structures, the component must be in the focus range (area of focus) of the
camera.
The focus range of the SIPLACE CP14 camera is between 9.4 and 11.4 mm (i.e. 10.4 +/– 1mm).
The focus range of the SIPLACE CP6/12 camera is between 15.4 +/– 2mm).
The Twin head positions the bottom side of the component into the correct focus plane of the camera if the nozzle length
and the component height are programmed correctly.
NOTICE
When selecting the correct nozzle for a component, check whether the total value of nozzle length plus compo-
nent height is within this range.
Example:
Nozzle length L = 9.600 mm
Component height H = 1.300 mm
Immersion depth = 0.200 mm
Overall height = nozzle length + component height - immersion depth = 10.700mm