AltaPail II Bulk Melters Product Manual - 第170页

Repair 10-8 Part 1121836_03 E 11/2014 Nordson Corporation This page intentiona lly left blank.

Repair

10-7

Part 1121836_03

E 11/2014 Nordson Corporation

Replacing Control Panel

You must purchase Service kit P/N: 394734. You will need the following

tools:

Electrical cabinet key

Open-end or box wrench, size 7

WARNING: Risk of electrical shock. Failure to observe may result in

personal injury, death, or equipment damage.

Installing Service Kit

WARNING: Disconnect the bulk melter from the line voltage.

1. Set the main switch to 0/OFF and Open electrical cabinet door.

2. Unplug bus cable from old control panel.

3. Release the M4 hexagon nuts and remove with the tooth lock washers.

4. Press old control panel and old seal forwards and out of the electrical

cabinet door.

5. Insert the new control panel and secure it using the tooth lock washers.

6. Plug bus cable into new control panel and then close the electrical

cabinet door.

7. Simultaneously turn on the main switch and hold down the key Heater

and the platen icon on the control panel until the LEDs on the control

panel light up once.

NOTE: When a new control panel has been installed, the following step

must be performed the next time the system is switched on:

Repair

10-8

Part 1121836_03

E 11/2014 Nordson Corporation

This page intentionally left blank.

Parts

11-1

Part 1121836_03

E 11/2014 Nordson Corporation

Section 11

Parts