GD450 说明书(中英文版） - 第67页

- 6 7 - Pix 4-12 (manual cleaning) 12 ：：刮刀设置按钮。单击该按钮后如图 4- 13 ，在此界面可设置前后刮刀压力零点位置；程序编辑完成后将 PCB 放置在运输导轨中间段，点击“ Z 轴到印刷位置” ，选择“刮刀轴点动”后点击“印刷轴后退”或者“印刷轴前进” ，使要测试的刮刀处于 PCB 位置，点击待测试刮刀的“找压力零点” ，刮刀会自动下降到接触钢网后停止，再同样测试另一个刮刀，完成后…

- 66 -

Pix 4-11(alarm record)

11：：人工清洗按钮。单击该按钮后如图 4-12；

: Manual cleaning. The interface in the pix 4-12 will be displayed by

clicking this button.

图 4-12（人工清洗）

- 67 -

Pix 4-12 (manual cleaning)

12：：刮刀设置按钮。单击该按钮后如图 4-13，在此界面可设置前后刮刀压

力零点位置；程序编辑完成后将 PCB 放置在运输导轨中间段，点击“Z

轴到印刷位置”，选择“刮刀轴点动”后点击“印刷轴后退”或者“印

刷轴前进”，使要测试的刮刀处于 PCB 位置，点击待测试刮刀的“找压

力零点”，刮刀会自动下降到接触钢网后停止，再同样测试另一个刮刀，

完成后升起刮刀并将 Z 轴回到零位，点击退出完成刮刀测试。

: Scraper setting. The interface in the pix 4-13 will be displayed by

clicking this button. Operator can setup the zero point position of front

and back scraper pressure. After the program has been edited, place

the PCB on the middle section of the transmission rail. Click “Z axis

lifts up to the printing position”button, select “the movement of scrape

axis point” and click “printing axis moves back” button or “printing

axis moves forward” button. Place the tested scraper in the PCB

position. Click “search the pressure zero point” button of the tested

scraper, the scraper will decline automatically to the stencil position

and stop after touching with the stencil. And test another scraper with

the same method. After finishing another scraper, lift up the scraper

and let Z axis return to the zero position. Click “退出”（exit）button,

then finish the scraper test.

- 68 -

图 4-13（刮刀设

13：：界面切换按钮。单击该按钮进行生产界面与主界面的切换；

: Interface shift. Do the shift of the production interface and main

interface by clicking this button.

14：：退出按钮。单击该按钮退出系统；

: Exit. Exit the system by clicking this button.

15：：开始按钮。单击该点击该按钮后系统会执行“判断运输导轨上有 PCB

板”、以及“提示是否调整运输导轨的宽度”等操作，依次点击是或否后机器执行印刷操