QP132三级参考手册.pdf.pdf - 第108页
Notes: Chapter 8 8.2 T raining Evaluation Edition 1.0 8-10 QP-132 Level 3 T utorial
8.2 Training Evaluation
Circle the most appropriate answer from the list below.
(1) To adjust pallet 10 mm shift:
a. a block jig is required.
b. a dial gauge is required.
c. Both a and b above.
(2) To adjust pallet pass through check sensor:
a. advance the 10 mm shift.
b. place a pallet against the stopper.
c. Both a and b above.
(3) To adjust the sensitivy of pallet arrival check sensor:
a. a jig is used.
b. a pallet is used.
c. Both a and b above.
(4) To adjust pallet shift, set the 10 mm shift to:
a. the forward position.
b. the retract position.
c. The position does not matter.
(5) Pallet Shift Forward and Backward End Sensor sensitivity is adjusted by:
a. the amp.
b. the position of the sensor.
c. the angle of the sensor.
Chapter 8 8.2 Training Evaluation
Edition 1.0 8-9 QP-132 Level 3 Tutorial
Notes:
Chapter 8 8.2 Training Evaluation
Edition 1.0 8-10 QP-132 Level 3 Tutorial
Chapter 9
Out Shifter